MPC7447A Ver la hoja de datos (PDF) - Freescale Semiconductor

Número de pieza

componentes Descripción

Fabricante

MPC7447A

RISC Microprocessor Hardware Specifications

Freescale Semiconductor 

Electrical and Thermal Characteristics

Table 7. Power Consumption for MPC7447A (continued)

1000

Processor (CPU) Frequency

1267

1333 5

1420 MHz

Unit

Notes

Typical

4.1

4.0

3.2

4.0

W

1, 2

Notes:

1. These values specify the power consumption for the core power supply (VDD) at nominal voltage and apply

to all valid processor bus frequencies and configurations. The values do not include I/O supply power (OVDD)

or PLL supply power (AVDD). OVDD power is system dependent but is typically < 5% of VDD power. Worst

case power consumption for AVDD < 3 mW.

2. Typical power is an average value measured at the nominal recommended VDD (see Table 4) and 65°C while

running the Dhrystone 2.1 benchmark and achieving 2.3 Dhrystone MIPs/MHz.

3. Maximum power is the average measured at nominal VDD and maximum operating junction temperature (see

Table 4) while running an entirely cache-resident, contrived sequence of instructions which keep all the

execution units maximally busy.

4. Doze mode is not a user-definable state; it is an intermediate state between full-power and either nap or sleep

mode. As a result, power consumption for this mode is not tested.

5. Power consumption for these devices is artificially constrained during screening to assure lower power

consumption than other speed grades.

5.2 AC Electrical Characteristics

This section provides the AC electrical characteristics for the MPC7447A. After fabrication, functional

parts are sorted by maximum processor core frequency as shown in Section 5.2.1, “Clock AC

Specifications,” and tested for conformance to the AC specifications for that frequency. The processor core

frequency is determined by the bus (SYSCLK) frequency and the settings of the PLL_CFG[0:4] signals,

and can be dynamically modified using dynamic frequency switching (DFS). Parts are sold by maximum

processor core frequency; see Section 11, “Ordering Information,” for information on ordering parts. DFS

is described in Section 9.8.5, “Dynamic Frequency Switching (DFS).”

5.2.1 Clock AC Specifications

Table 8 provides the clock AC timing specifications as defined in Figure 3 and represents the tested

operating frequencies of the devices. The maximum system bus frequency, fSYSCLK, given in Table 8, is

considered a practical maximum in a typical single-processor system. The actual maximum SYSCLK

frequency for any application of the MPC7447A will be a function of the AC timings of the MPC7447A,

the AC timings for the system controller, bus loading, printed-circuit board topology, trace lengths, and so

forth, and may be less than the value given in Table 8.

NOTE

The core frequency information in this table applies when operating the

device at the nominal core voltage indicated in Table 4. For core frequency

specifications at derated core voltage conditions, see Section 5.3, “Voltage

and Frequency Derating.”

MPC7447A RISC Microprocessor Hardware Specifications, Rev. 5

14

Freescale Semiconductor

Share Link: