9 COMMAND DESCRIPTIONS
9.1 Set Lower Column Address
This command specifies the lower nibble of the 7-bit column address of the display data RAM. The
column address will be incremented by each data access after it is pre-set by the MCU and
returning to 0 once overflow (>95 when MODE=H OR >103 when MODE=L).
9.2 Set Upper Column Address
This command specifies the higher nibble of the 7-bit column address of the display data RAM.
The column address will be incremented by each data access after it is pre-set by the MCU and
returning to 0 once overflow (>95 when MODE=H OR >103 when MODE=L).
9.3 Set Internal Regulator Resistor Ratio
This command is to enable any one of the eight internal resistor (IRS) settings for different
regulator gains when using internal regulator resistor network. The Contrast Control Voltage Range
curves is referred to the following formula:
Vout
=
1 +
R2
R1
*Vcon
Vcon
=
1 −
63 − α
210
* Vref
, where Vref = 1.7V
25
SSD0858
Rev 1.0
11/2002
SOLOMON