SSD0858Z Ver la hoja de datos (PDF) - Solomon Systech
Número de pieza
componentes Descripción
Fabricante
SSD0858Z Datasheet PDF : 45 Pages
| |||
8 COMMAND TABLE
Table 5 - COMMAND TABLE
Bit Pattern
0000 C3C2C1C0
0001 0C6C5C4
0010 0R2R1R0
Command
Set Lower Column
Address
Set Upper Column
Address
Set Internal Regulator
Resistor Ratio
0010 1VC VR VF
0011 1T2T1T0
Set Power Control
Register
Set TC value
0100 00XX
XL6L5L4 L3L2L1L0
0100 01XX
XXC5C4 C3C2C1C0
Set Display Start Line
Set Display Offset
Description
Set the lower nibble of the column address pointer for
RAM access. The pointer is reset to 0 after reset.
Set the upper nibble of the column address pointer for
RAM access. The pointer is reset to 0 after reset.
The internal regulator gain (1+R2/R1) Vout increases as
R2R1R0 is increased from 000b to 111b. The factor,
1+R2/R1, is given by:
R2R1R0 = 000: 2.84 (POR)
R2R1R0 = 001: 3.71
R2R1R0 = 010: 4.57
R2R1R0 = 011: 5.44
R2R1R0 = 100: 6.30
R2R1R0 = 101: 7.16
R2R1R0 = 110: 8.03
R2R1R0 = 111: 8.89
VC=0: turn OFF the internal voltage booster (POR)
VC=1: turn ON the internal voltage booster & regulator
VR=0: turn OFF the internal regulator (POR)
VR=1: turn ON the internal regulator & voltage booster
VF=0: turn OFF the output op-amp buffer (POR)
VF=1: turn ON the output op-amp buffer
This command set the Temperature Coefficient
T2T1T0:
000: -0.01%/oC
001: -0.035%/oC
010: -0.05%/oC
011: -0.083%/oC
100: -0.14%/oC(POR)
101: Reserved
110: Reserved
111: Reserved
The second command specifies the row address
pointer (0-63) of the RAM data to be displayed in
COM0. This command has no effect on ICONS. The
pointer is set to 0 after reset.
The second command specifies the mapping of first
display line (COM0) to one of ROW0~63. This
command has no effect on ICONS. COM0 is mapped to
ROW0 after reset.
SSD0858
Rev 1.0
11/2002
18
SOLOMON
Share Link: 