ST20-JPI-UK Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

ST20-JPI-UK

PC PARALLEL PORT TO JTAG INTERFACE

STMicroelectronics 

ST20-JPI

2.2 Hardware Installation - B300

The ST20-JPI can also be attached to the Ethernet via a B300. To install the hardware connecting

to a B300, the following steps should be followed:

• Connect the B300 to the ST20-JPI using a Differential OS-Link cable supplied with the

B300.

• Plug the target development system into the 20-way IDC connector using a 20 way IDC

cable.

• Plug power supply cable into PSU socket of the interface.

• Plug the power supply into the mains socket.

• Switch on the B300.

• Switch on the power supply to the ST20-JPI. The LEDs on the interface should illuminate

once the software is running. For a description of the meaning of the LEDs, see the ST20

toolset documentation.

• Switch on the Target power supply.

2.3 Software Installation

For installation of the DLL and VxD drivers, please refer to the ST20 Toolset software installation

documentation.

5/10

®

Share Link: