ST20-JPI-UK Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

ST20-JPI-UK

PC PARALLEL PORT TO JTAG INTERFACE

STMicroelectronics 

ST20-JPI

3.5 TrigIn/TrigOut SMB Coaxial Connectors

The two coaxial SMB connectors to the left of the LEDs are used to connect the ST20-JPI to a

Logic Analyser. They are used to signal between the Host, Target and Logical Analyser when an

event occurs. If, for instance, an event occurs on the Target processor, the TrigOut signal is

triggered which could start the Logic Analyser tracing an external event, so aiding software/

hardware debugging.

TrigIn/Out

GND

3.6 Power Supply Connector

The ST20-JPI uses a 2.5mm power connector. The voltage range is 8-13V dc.

+V

GND

4 Recommended Target Circuitry

To ensure correct connection to the target processor, the following circuit should be used:

ST20-JPI

10K

Board PowerOnReset

VCC

ST20

TDO

TDI

TMS

TCK

notTRST

TrigIn

TrigOut

notRST

Target Board

8/10

®

Share Link: