ST20-JPI
1 Introduction
The ST20-JPI parallel port to JTAG interface is a host interface to allow connection from a PC
parallel port to any JTAG based ST20 development board. The interface plugs into any standard
PC 25 way D-type parallel port. Supported parallel port modes are:
• Nibble mode
• Byte mode
• EPP mode
depending on which mode the host PC can support. Connection to the development target is via a
JTAG connector. Once connected, the development target can be accessed using the MS Windows
drivers supplied with the standard ST20 toolset.
3/10
®