C5100 Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

C5100

HP Photosmart C5100 All-in-One series Basics Guide

Unspecified 

Chapter 1

Connect the HP All-in-One to the network

An Ethernet port is provided on the back of the HP All-in-One.

To connect the HP All-in-One to the network

1. Remove the yellow plug from the back of the HP All-in-One.

2. Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

3. Connect the other end of the Ethernet cable to an available port on your Ethernet

router or switch.

4. Once you have connected the HP All-in-One to the network, install the software.

Install the software for a network connection

Use this section to install the HP All-in-One software on a computer connected to a

network. Before you install the software, make sure you have connected the HP All-in-

One to a network.

Note 1 If your computer is configured to connect to a series of network drives,

make sure that your computer is currently connected to these drives before

installing the software. Otherwise, HP All-in-One installation software might try to

use one of the reserved drive letters, and you will not be able to access that

network drive on your computer.

Note 2 Installation time can range from 20 to 45 minutes depending on your

operating system, the amount of available space, and the processor speed of

your computer.

8

HP Photosmart C5100 All-in-One series

Share Link: