1EDI2004AS Ver la hoja de datos (PDF) - Infineon Technologies
Número de pieza
componentes Descripción
Fabricante
1EDI2004AS Datasheet PDF : 138 Pages
| |||
EiceDRIVERTM SIL
1EDI2004AS
Specification
5.5.6 Desaturation Protection
Table 57 DESAT characteristics
Parameter
Symbol
Values
Unit Note or Test Condition
DESAT Input voltage range
DESAT Source Current
DESAT Reference Level
DESAT Pull-up Resistance
DESAT Low Voltage
Min. Typ. Max.
V15DESAT 0
IDESAT
0
VDESAT0 8.4
RPUDSAT2 19
VDESATL
-
-
VCC2
V
-
2
mA
9
9.4
V
30
46
kΩ
200 -
mV
DESAT blanking time deviation from dtDESATBL -20
-
programmed value
+20 %
1) Pin is robust against negative transient (300mA/500ns).
2) Not subject to production test. This parameter is verified by design / characterization.
Referenced to GND2 1) 2)
rms value 2)
VCC2 =typ., VEE2 =typ.
to VCC2
Referenced to GND2,
Desat clamping
enabled, Isink= 5mA.2)
After transition of the
PWM command,
assuming a 1 µs
programmed blanking
time, fclk2 = typ.2)
5.5.7 Overcurrent Protection
Table 58 OCP characteristics
Parameter
Symbol
Values
Unit Note or Test Condition
Min. Typ. Max.
OC error detection threshold
VOCPD1
270
300
330
mV Referenced to OCPG
282 300 318 mV Referenced to OCPG,
Tj= 150°C
OCP blanking time deviation from dtOCPBL -20
-
programmed value
+20 % After transition of the
PWM command,
assuming a 1 µs
programmed blanking
time, fclk2 = typ.1)
OCP Pull-up Resistance
RPUOCP2 40
100
175
kΩ to internal 5V
reference.
1) Not subject to production test. Parameters are verified by design / characterization.
Data Sheet
132
Rev. 2.0
2019-01-16
Share Link: 