AN555
2.2. Si483x-B/Si4820/24 Band Selection
Refer to Figure 1 below for the band selection circuits. Selecting a band determines the resistance value from the
band select pin to GND.
To select a specific band, you need to ensure two things:
1. Total value of resistance from the BAND to GND is equal to the value specified in Table 2
2. Total resistance from TUNE1 to GND is 500 k in 1% tolerance
The following sections describe some commonly used bands and their respective selection circuits.
2.2.1. Typical 12-band application
Figure 1 and Table 3 illustrate the band and resistor value details for a typical 12-band application.
4
Rev. 0.2