MX25L6406E(2010) Ver la hoja de datos (PDF) - Macronix International

Número de pieza

componentes Descripción

Fabricante

MX25L6406E
(Rev.:2010)

64M-BIT [x 1 / x 2] CMOS SERIAL FLASH

Macronix International 

MX25L6406E

HOLD FEATURES

HOLD# pin signal goes low to hold any serial communications with the device. The HOLD feature will not stop the

operation of write status register, programming, or erasing in progress.

The operation of HOLD requires Chip Select(CS#) keeping low and starts on falling edge of HOLD# pin signal

while Serial Clock (SCLK) signal is being low (if Serial Clock signal is not being low, HOLD operation will not start

until Serial Clock signal being low). The HOLD condition ends on the rising edge of HOLD# pin signal while Se-

rial Clock(SCLK) signal is being low( if Serial Clock signal is not being low, HOLD operation will not end until Serial

Clock being low), see Figure 2.

Figure 2. Hold Condition Operation

CS#

SCLK

HOLD#

Hold

Condition

(standard)

Hold

Condition

(non-standard)

The Serial Data Output (SO) is high impedance, both Serial Data Input (SI) and Serial Clock (SCLK) are don't care

during the HOLD operation. If Chip Select (CS#) drives high during HOLD operation, it will reset the internal logic of

the device. To re-start communication with chip, the HOLD# must be at high and CS# must be at low.

P/N: PM1577

REV. 1.1, NOV. 17, 2010

13

Share Link: