AT91M40800-33AU Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

AT91M40800-33AU

AT91 ARM Thumb Microcontrollers

Atmel Corporation 

AT91M40800

5. Architectural Overview

The AT91M40800 microcontroller integrates an ARM7TDMI with Embedded ICE interface,

memories and peripherals. The architecture consists of two main buses, the Advanced System

Bus (ASB) and the Advanced Peripheral Bus (APB). Designed for maximum performance and

controlled by the memory controller, the ASB interfaces the ARM7TDMI processor with the on-

chip 32-bit memories, the External Bus Interface (EBI) and the AMBA™ Bridge. The AMBA

Bridge drives the APB, which is designed for accesses to on-chip peripherals and optimized for

low power consumption.

The AT91M40800 microcontroller implements the ICE port of the ARM7TDMI processor on ded-

icated pins, offering a complete, low cost and easy-to-use debug solution for target debugging.

5.1 Memories

The AT91M40800 microcontroller embeds up to 8K bytes of internal SRAM. The internal mem-

ory is directly connected to the 32-bit data bus and is single-cycle accessible.

The AT91M40800 microcontroller features an External Bus Interface (EBI), which enables con-

nection of external memories and application-specific peripherals. The EBI supports 8- or 16-bit

devices and can use two 8-bit devices to emulate a single 16-bit device. The EBI implements the

early read protocol, enabling faster memory accesses than standard memory interfaces.

5.2 Peripherals

The AT91M40800 microcontrollers integrate several peripherals, which are classified as system

or user peripherals. All on-chip peripherals are 32-bit accessible by the AMBA Bridge, and can

be programmed with a minimum number of instructions. The peripheral register set is composed

of control, mode, data, status and enable/disable/status registers.

An on-chip Peripheral Data Controller (PDC) transfers data between the on-chip USARTs and

on- and off-chip memories address space without processor intervention. Most importantly, the

PDC removes the processor interrupt handling overhead, making it possible to transfer up to

64K contiguous bytes without reprogramming the start address, thus increasing the perfor-

mance of the microcontroller, and reducing the power consumption.

5.2.1

System Peripherals

The External Bus Interface (EBI) controls the external memory or peripheral devices via an 8- or

16-bit databus and is programmed through the APB. Each chip select line has its own program-

ming register.

The Power-saving (PS) module implements the Idle mode (ARM7TDMI core clock stopped until

the next interrupt) and enables the user to adapt the power consumption of the microcontroller to

application requirements (independent peripheral clock control).

The Advanced Interrupt Controller (AIC) controls the internal interrupt sources from the internal

peripherals and the four external interrupt lines (including the FIQ), to provide an interrupt and/or

fast interrupt request to the ARM7TDMI. It integrates an 8-level priority controller and, using the

Auto-vectoring feature, reduces the interrupt latency time.

The Parallel Input/Output Controller (PIO) controls up to 32 I/O lines. It enables the user to

select specific pins for on-chip peripheral input/output functions, and general-purpose input/out-

put signal pins. The PIO controller can be programmed to detect an interrupt on a signal change

from each line.

5

1348FS–ATARM–13-Apr-06

Share Link: