RT9203GS Ver la hoja de datos (PDF) - Richtek Technology
Número de pieza
componentes Descripción
Fabricante
RT9203GS Datasheet PDF : 16 Pages
| |||
Preliminary
RT9203/A
Application Information
The RT9203/A operates at either single 5V power supply
with a bootstrap UGATE driver or a 5V/12V dual-power
VCC
supply form the ATX SMPS. The dual- power supply is
recommended for high current applications, the RT9203/
A can deliver higher gate driving current while operating
with ATX SMPS based on a dual-power supply.
6.0V
Regulation
BOOT
UGATE
R
C 10
1uF
12V
5V
The Bootstrap Operation
In a single power supply system, the UGATE driver of
RT9203/A is powered by an external bootstrap circuit, as
shown in the Figure 3. The boot capacitor, CBOOT,
generates a floating reference at the PHASE pin. Typically
a 0.1µF CBOOT is enough for most of MOSFETs used
with the RT9203/A. The voltage drop between BOOT and
PHASE is refreshed to a voltage of VCC - diode drop
(VD) while the lower MOSFET turning on.
R1
VCC
BOOT
D1
5V
C2
1uF
UGATE
0.1uF
PHASE
VCC
LGATE
RT9203/A
Figure 3. Single 5V power Supply Operation
VCC
LGATE
C2
1uF
RT9203/A
Figure 4. Dual Power Supply Operation
Power On Reset
The Power-On Reset (POR) monitors the supply voltage
(normal +5V) at the VCC pin and the input voltage at the
OCSET pin. The VCC POR level is set to 4.1V with 0.5V
hysteresis and the normal level at OCSET pin is set to
1.5V (see over-current protection). The POR function
initiates soft-start operation after all supply voltages
exceed their POR thresholds.
Soft Start
A built-in soft-start is used to prevent surge current from
power supply input during powering on. The soft-start
voltage is controlled by an internal digital counter. It slows
down and clamps the ramping of reference voltage at the
input of error amplifier and the pulse-width of the output
driver. The typical soft-start duration is 2.5ms.
Dual Power Operation
The RT9203/A was designed to supply a regulated 6.0V
at VCC pin automatically when BOOT pin is powered by
a 12V. In a system with ATX 5V/12V power supply, the
RT9203/A is ideal for higher current applications due to
the higher gate driving capability, VUGATE = 12V and VLGATE
= 6.0V. A RC (10Ω/1µF) filter is also recommended at
BOOT pin to prevent the ringing induced from fast power-
on, as shown in Figure 4.
Under Voltage and Over Voltage Protection
The voltage presents at FB pin is monitored and protected
against OC (over current), UV (under voltage), and OV
(over voltage). The UV threshold is 0.5V and OV threshold
is 1.0V. Both UV and OV detection are with 30ms delay
after triggered. When OC or UV trigged, a hiccup re-start
sequence will be initialized, as shown in Figure 5. For
RT9203, Only 3 times of trigger are allowed before
latching off. But for RT9203A, UVP will be kept in hiccup
mode. Hiccup is disabled during soft-start interval.
DS9203/A-10 March 2007
www.richtek.com
11
Share Link: 