MX29LV004B Ver la hoja de datos (PDF) - Macronix International
Número de pieza
componentes Descripción
Fabricante
MX29LV004B Datasheet PDF : 54 Pages
| |||
MX29LV004T/B
TABLE 6. EXPANDED SILICON ID CODE
Pins
Manufacture code
Device code
for MX29LV004T
Device code
for MX29LV004B
Sector Protection
Verification
A0 A1 Q7 Q6 Q5 Q4 Q3 Q2 Q1 Q0 Code(Hex)
VIL VIL 1 1
0
0
0
0
1
0
C2H
VIH VIL 1 0
1
1
1
0
0
1
22B9H
VIH VIL 1 0
1
1
1
0
0
1
B5H
VIH VIL 1 0
1
1
1
0
1
0
22BAH
VIH VIL 1 0
1
1
1
0
1
0
B6H
X VIH 0 0
0
0
0
0
0
1
01H (Protected)
X VIH 0 0
0
0
0
0
0
0
00H (Unprotected)
READING ARRAY DATA
The device is automatically set to reading array data
after device power-up. No commands are required to
retrieve data. The device is also ready to read array data
after completing an Automatic Program or Automatic
Erase algorithm.
After the device accepts an Erase Suspend command,
the device enters the Erase Suspend mode. The sys-
tem can read array data using the standard read tim-
ings, except that if it reads at an address within erase-
suspended sectors, the device outputs status data. After
completing a programming operation in the Erase
Suspend mode, the system may once again read array
data with the same exception. See rase Suspend/Erase
Resume Commands” for more infor-mation on this mode.
The system must issue the reset command to re-en-
able the device for reading array data if Q5 goes high, or
while in the autoselect mode. See the "Reset Command"
section, next.
RESET COMMAND
Writing the reset command to the device resets the
device to reading array data. Address bits are don't care
for this command.
The reset command may be written between the se-
quence cycles in an erase command sequence before
erasing begins. This resets the device to reading array
data. Once erasure begins, however, the device ignores
reset commands until the operation is complete.
The reset command may be written between the se-
quence cycles in a program command sequence be-fore
programming begins. This resets the device to reading
array data (also applies to programming in Erase
Suspend mode). Once programming begins,however, the
device ignores reset commands until the operation is
complete.
The reset command may be written between the se-
quence cycles in an SILICON ID READ command
sequence. Once in the SILICON ID READ mode, the
reset command must be written to return to reading array
data (also applies to SILICON ID READ during Erase
Suspend).
If Q5 goes high during a program or erase operation,
writing the reset command returns the device to read-
ing
array data (also applies during Erase Suspend).
P/N:PM0732
REV. 1.1, SEP. 19, 2001
11
Share Link: 