AS8168 Ver la hoja de datos (PDF) - austriamicrosystems AG

Número de pieza

componentes Descripción

Fabricante

AS8168

Single Phase Average Energy Metering IC with On-Chip Calibration, Stepper Motor Drive and LED Output

austriamicrosystems AG 

Data Sheet AS8168

Direction Input (DIRI)

The direction input pin (DIRI) is used to program the AS8168 for either bi-directional energy measurement, or unidirectional

measurement.

Bi-directional measurement mode ensures that all energy is measured regardless of the direction of the current through the

current sensor. In unidirectional energy measurement mode, all negative going energy is suppressed and thus excluded from

the accumulated energy value.

The programming conditions for the DIRI pin are given below:

DIRI Pin

0

1

Mode

Unidirectional

Bi-directional

The default condition, when the DIRI pin is not connected is bi-directional energy measurement, as the DIRI pin has an on-

chip pull-up resistor.

Direction Output (DIRO)

The Direction Output pin (DIRO) is a logic output providing information on the direction of the current flow through the current

sensor. The DIRO output may be used to directly drive an LED to indicate a reversal in the direction of current flow.

The conditions that will initiate a change in the DIRO logic output are given below:

If DIRI = 1 (bi-directional mode) DIRO changes only when there is a pulse at CAL or LED.

If DIRI = 0 (unidirectional mode) DIRO changes at a zero-crossing when not in anti-creep.

The timing diagram below demonstrates the operation of the DIRO output and the pulse outputs (MOP/MON, CAL and LED)

relative to the sign of the measured energy and the setting of the DIRI input.

For illustration purposes, the timing diagram below only shows the LED output.

1

2

3

4

VP

IP

DIRI

LED

DIRO

Figure 5 Timing diagram for the DIRI and DIRO functions

Revision 1.2, 11-Feb-05

Page 11 of 30

Share Link: