W83977ATF Ver la hoja de datos (PDF) - Winbond

Número de pieza

componentes Descripción

Fabricante

W83977ATF

WINBOND I/O

Winbond 

W83977ATF

FEATURES

General

• Plug & Play 1.0A compatible

• Support 13 IRQs, 4 DMA channels, full 16-bit address decoding

• Capable of ISA Bus IRQ Sharing

• Compliant with Microsoft PC97 Hardware Design Guide

• Support DPM (Device Power Management), ACPI

• Report ACPI status interrupt by SCI signal issued from any of the 13 IQRs pins or GPIO xx

• Programmable configuration settings

• Single 24/48 Mhz clock input

FDC

• Compatible with IBM PC AT disk drive systems

• Variable write pre-compensation with track selectable capability

• Support vertical recording format

• DMA enable logic

• 16-byte data FIFOs

• Support floppy disk drives and tape drives

• Detects all overrun and underrun conditions

• Built-in address mark detection circuit to simplify the read electronics

• FDD anti-virus functions with software write protect and FDD write enable signal (write data signal

was forced to be inactive)

• Support up to four 3.5-inch or 5.25-inch floppy disk drives

• Completely compatible with industry standard 82077

• 360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps data transfer rate

• Support 3-mode FDD, and its Win95 driver

UART

• Two high-speed 16550 compatible UARTs with 16-byte send/receive FIFOs

• MIDI compatible

• Fully programmable serial-interface characteristics:

--- 5, 6, 7 or 8-bit characters

--- Even, odd or no parity bit generation/detection

--- 1, 1.5 or 2 stop bits generation

• Internal diagnostic capabilities:

--- Loop-back controls for communications link fault isolation

--- Break, parity, overrun, framing error simulation

• Programmable baud generator allows division of 1.8461 Mhz and 24 Mhz by 1 to (216-1)

• Maximum baud rate up to 921k bps for 14.769 Mhz and 1.5M bps for 24 Mhz

Publication Release Date: October 2001

-2-

Revision 0.53

Share Link: