INT Pins
Option
Pull-up resistor, pull-
down resistor or
resistor open selection
High or low level hold
transistor selection
Rising edge or falling
edge detection
selection
RES Pin
Option
Pull-up resistor, pull-
down resistor or
resistor open and
reset level selection
Pins N1 to N4
Option
N-channel/CMOS
selection
LC587008, 587006, 587004
Circuit configuration
Note
Built-in resistor selection
• Pull-up resistor used
• Pull-down resistor used
• Used open
Input signal level hold transistor selection
• High level hold transistor used
• Low level hold transistor used
• Level hold transistors unused
Signal change edge detection switching
• Change on rising signal
• Change on falling signal
Circuit configuration
Note
Built-in resistor and polarity selection
• Pull-up resistor connected, low level reset
• Pull-down resistor connected, high level
reset
• Resistors open, low level reset
• Resistors open, high level reset
Circuit configuration
Note
• Selection of CMOS or n-channel open drain
circuit type
• Pins N1 to N4 can be specified
independently
• The output level during reset can be
specified.
— High level
— Low level
No. 4435-11/29