3750 Ver la hoja de datos (PDF) - 3M
Número de pieza
componentes Descripción
Fabricante
3750 Datasheet PDF : 3 Pages
| |||
3
Hot Melt Adhesive
3750LM • 3750
Technical Data
July, 2016
Product Description
3M™ Hot Melt Adhesives are heat applied, 100% solids adhesives. They are fast setting
thermoplastic adhesives with good “hot tack” and low to medium viscosity.
3M™ Hot Melt Adhesives bond to a wide variety of substrates such as corrugated,
beadboard, repacking chipboard, recouperage, wood and many other lightweight
materials.
3M™ Hot Melt 3750 Tan
Low viscosity adhesive for high flow rate and increased
production rate. Ideal for high volume packaging. Use
with AE II applicator only.
3M™ Hot Melt 3750 Clear General purpose adhesive with high peel strength. Use
with AE II applicator only
3M™ Hot Melt 3750LM Low temperature application version with a fast set time.
Use with AEII LT applicator only.
Fe ature s
100% solids, no VOCs
Easy to use
Fast-setting adhesive obtains strength in seconds
Low Melt (LM) adhesives are designed for low temperature application and heat
sensitive substrates
“Quick grab” for instant adhesion that cools to a tack free solid
Ideal for packaging and many woodworking applications.
Typical Physical
Prope rties
Note: The following technical information and data should be considered representative
or typical only and should not be used for specification purposes.
3M™ Hot Melt Adhesive
3750LM
3750 Tan
3750 Clear
Color (solid)
Tan
Tan
Clear
De nsity (g/cm3)
1.01
0.93
0.93
Flashpoint (°F)
560
>390
>530
Directions for
Use
1. Application: 3M™ Hot Melt Adhesives are designed for use with 3M™ Hot Melt
Applicators (excluding bulk sizes). 3M™ Hot Melts are applied at 350-385°F,
except the LM series which are designed to be applied at 250-275°F. Read and
follow the precautions and directions for use in the Applicators User’s Manual before
operating the applicator.
Open Time is the maximum amount of time between dispensing adhesive and joining
surfaces. Reported open time are based on 1/8” extruded beads and will vary based on bead
size, dispense temperature and ambient temperature.
Extruded bead sizes can be customized using 3M™ applicator tips.
Share Link: 