4/ (FOLSVH3OXV 'DWD 6KHHW 5HY $
7DEOH ,QSXW 5HJLVWHU &HOO
6\PERO
3DUDPHWHU
9DOXH
,QSXW 5HJLVWHU &HOO 2QO\
0LQ 0D[
tISU
Input register setup time: time the synchronous input of the flip-flop must be stable
before the active clock edge
3.12 ns
-
tIHL
Input register hold time: time the synchronous input of the flip-flop must be stable
after the active clock edge
0 ns
-
tICO
Input register clock-to-out: time taken by the flip-flop to output after the active clock
edge
- 1.08 ns
tIRST
Input register reset delay: time between when the flip-flop is “reset”(low) and when
the output is consequently “reset” (low)
- 0.99 ns
tIESU
Input register clock enable setup time: time “enable” must be stable before the
active clock edge
0.37 ns
-
tIEH
Input register clock enable hold time: time “enable” must be stable after the active
clock edge
0 ns
-
7DEOH 6WDQGDUG ,QSXW 'HOD\V
6\PERO
3DUDPHWHU
6WDQGDUG ,QSXW 'HOD\V
7R JHW WKH WRWDO LQSXW GHOD\ DGG WKLV GHOD\ WR W,68
tSID (LVTTL)
tSID (LVCMOS2)
LVTTL input delay: Low Voltage TTL for 3.3 V applications
LVCMOS2 input delay: Low Voltage CMOS for 2.5 V and lower
applications
tSID (GTL+)
tSID (SSTL3)
tSID (SSTL2)
GTL+ input delay: Gunning Transceiver Logic
SSTL3 input delay: Stub Series Terminated Logic for 3.3 V
SSTL2 input delay: Stub Series Terminated Logic for 2.5 V
9DOXH
0LQ 0D[
- 0.34 ns
- 0.42 ns
- 0.68 ns
- 0.55 ns
- 0.61 ns
WWWWWW ZZZTXLFNORJLFFRP
R
CLK
D
tISU
t IHL
Q
tICO
t IRS T
E
tIESU tIEH
)LJXUH (FOLSVH3OXV ,QSXW 5HJLVWHU &HOO 7LPLQJ
4XLFN/RJLF &RUSRUDWLRQ