VNI8200XP-32 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

VNI8200XP-32

Octal high-side smart power solid-state relay with serial/parallel selectable interface on-chip

STMicroelectronics 

Description

VNI8200XP-32

1

Description

The VNI8200XP-32 is a monolithic 8-channel driver featuring a very low supply current,

with integrated SPI interface and high efficiency 100 mA micropower step-down switching

regulator peak current control loop mode. The IC, realized in STMicroelectronics

VIPower™ technology, is intended to drive any kind of load with one side connected to

ground.

Active channel current limitation combined with thermal shutdown, independent for each

channel, and automatic restart, protect the device against overload.

Additional embedded functions are: loss of GND protection that automatically turns off the

device outputs in case of ground disconnection, undervoltage shutdown with hysteresis,

Power Good diagnostic for valid supply voltage range recognition, output enable function

for immediate power outputs ON/OFF, and programmable watchdog function for

microcontroller safe operation; case overtemperature protection to control the IC case

temperature.

The device embeds a four-wire SPI serial peripheral with selectable 8 or 16-bit operations;

through a select pin the device can also operate with a parallel interface.

Both the 8-bit and 16-bit SPI operations are compatible with daisy chain connection.

The SPI interface allows command of the output driver by enabling or disabling each

channel featuring, in 16-bit format, a parity check control for communication robustness. It

also allows the monitoring of the status of the IC signaling Power Good, overtemperature

condition for each channel, IC pre-warning temperature detection.

Built-in thermal shutdown protects the chip from overtemperature and short-circuit. In

overload condition, the channel turns OFF and ON again automatically after the IC

temperature decreases below a threshold fixed by a temperature hysteresis so that junction

temperature is controlled. If this condition makes case temperature reaching case

temperature limit, TCSD, overloaded channels are turned OFF and restart, non-

simultaneously, when case and junction temperature decrease below their own reset

threshold. If the case of thermal reset, the channels loaded are not switched on until the

junction temperature reset event. Non-overloaded channels continue to operate normally.

Case temperature above TCSD is reported through the TWARN open drain pin.

An internal circuit provides a not latched common FAULT indicator reporting if one of the

following events occurs: channel OVT (overtemperature), parity check fail. The Power

Good diagnostic warns the controller that the supply voltage is below a fixed threshold.

The watchdog function is used to detect the occurrence of a software fault of the host

controller. The watchdog circuitry generates an internal reset on expiry of the internal

watchdog timer. The watchdog timer reset can be achieved by applying a negative pulse

on the WD pin. The watchdog function can be disabled by the WD_EN dedicated pin. This

pin also allows the programming of a wide range of watchdog timings.

An internal LED matrix driver circuitry (4 rows, 2 columns) allows the detection of the status

of the single outputs. An integrated step-down voltage regulator provides supply voltage to

the internal LED matrix driver and logic output buffers and can be used to supply the

external optocouplers if the application requires isolation. The regulator is protected against

short-circuit or overload conditions thanks to pulse-by-pulse current limit with a peak

current control loop.

6/43

DocID027849 Rev 3

Share Link: