ISL29009 Ver la hoja de datos (PDF) - Renesas Electronics
Número de pieza
componentes Descripción
Fabricante
ISL29009 Datasheet PDF : 7 Pages
| |||
ISL29009
Application Information
Light-to-Current and Voltage Conversion
The ISL29009 has responsiveness that is a square-root
function of the light intensity intercepted by the photodiode in
lux. Because the photodiode has a responsivity that resembles
the human eye, conversion rate is independent of the light
source (fluorescent light, incandescent light or direct sunlight).
IOUT
=
----1---.--8--------A-----
100 l u x
E
(EQ. 1)
Here, IOUT is the output current in µA, and E is the input light
in lux.
A load resistor RL is added to convert IOUT into VOUT. The
output voltage can be expressed in Equation 2:
VOUT
=
IOUT RL
=
----1---.--8--------A-----
100 l u x
E RL
(EQ. 2)
Here, VOUT is the output voltage and RL is the value of the
load resistor added. The compliance of the ISL29009's
output circuit may result in premature saturation of the
output current and voltage when an excessively large RL is
used. The output compliance voltage is 200mV below the
supply voltage as listed in VO-MAX of the “Electrical
Specifications” table on page 2.
Optical Sensor Location Outline
The green area in Figure 18 shows the optical sensor
location outline of ISL29009. Along the pin-out direction, the
center line (CL) of the sensor coincides with that of the
packaging. The sensor width in this direction is 0.39mm.
Perpendicular to the pin-out direction, the CL of the sensor
has an 0.19mm offset from the CL of packaging away from
pin-1. The sensor width in this direction is 0.46mm.
2.10mm
2.00mm
0.19mm
29009
0.46mm
0.39mm
FIGURE 18. 6 LD ODFN SENSOR LOCATION OUTLINE
© Copyright Intersil Americas LLC 2008. All Rights Reserved.
All trademarks and registered trademarks are the property of their respective owners.
For additional products, see www.intersil.com/en/products.html
Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil may modify the circuit design and/or specifications of products at any time without notice, provided that such
modification does not, in Intersil's sole judgment, affect the form, fit or function of the product. Accordingly, the reader is cautioned to verify that datasheets are
current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its
subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN6484 Rev 0.00
July 1, 2008
Page 6 of 7
Share Link: 