29F010 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

29F010

1 Mbit (128Kb x8, Uniform Block) Single Supply Flash Memory

STMicroelectronics 

M29F010B

Block Erase operation and return the memory to

Read mode. The command requires one Bus

Write operation.

The Program/Erase Controller will suspend within

15µs of the Erase Suspend Command being is-

sued. Once the Program/Erase Controller has

stopped the memory will be set to Read mode and

the Erase will be suspended. If the Erase Suspend

command is issued during the period when the

memory is waiting for an additional block (before

the Program/Erase Controller starts) then the

Erase is suspended immediately and will start im-

mediately when the Erase Resume Command is

issued. It will not be possible to select any further

blocks for erasure after the Erase Resume.

During Erase Suspend it is possible to Read and

Program cells in blocks that are not being erased;

both Read and Program operations behave as

normal on these blocks. Reading from blocks that

are being erased will output the Status Register. It

is also possible to enter the Auto Select mode: the

memory will behave as in the Auto Select mode on

all blocks until a Read/Reset command returns the

memory to Erase Suspend mode.

Erase Resume Command. The Erase Resume

command must be used to restart the Program/

Erase Controller from Erase Suspend. An erase

can be suspended and resumed more than once.

Table 5. Commands

Bus Write Operations

Command

1st

2nd

3rd

4th

5th

6th

Addr Data Addr Data Addr Data Addr Data Addr Data Addr Data

Read/Reset

1 X F0

3 555 AA 2AA 55 X F0

Auto Select

3 555 AA 2AA 55 555 90

Program

4 555 AA 2AA 55 555 A0 PA PD

Unlock Bypass

3 555 AA 2AA 55 555 20

Unlock Bypass

Program

2 X A0 PA PD

Unlock Bypass Reset 2 X 90 X 00

Chip Erase

6 555 AA 2AA 55 555 80 555 AA 2AA 55 555 10

Block Erase

6+ 555 AA 2AA 55 555 80 555 AA 2AA 55 BA 30

Erase Suspend

1 X B0

Erase Resume

1 X 30

Note: X Don’t Care, PA Program Address, PD Program Data, BA Any address in the Block.

All values in the table are in hexadecimal.

The Command Interface only uses address bits A0-A10 to verify the commands, the upper address bits are Don’t Care.

Read/Reset. After a Read/Reset command, read the memory as normal until another command is issued.

Auto Select. After an Auto Select command, read Manufacturer ID, Device ID or Block Protection Status.

Program, Unlock Bypass Program, Chip Erase, Block Erase. After these commands read the Status Register until the Program/Erase

Controller completes and the memory returns to Read Mode. Add additional Blocks during Block Erase Command with additional Bus Write

Operations until the Timeout Bit is set.

Unlock Bypass. After the Unlock Bypass command issue Unlock Bypass Program or Unlock Bypass Reset commands.

Unlock Bypass Reset. After the Unlock Bypass Reset command read the memory as normal until another command is issued.

Erase Suspend. After the Erase Suspend command read non-erasing memory blocks as normal, issue Auto Select and Program commands

on non-erasing blocks as normal.

Erase Resume. After the Erase Resume command the suspended Erase operation resumes, read the Status Register until the Program/

Erase Controller completes and the memory returns to Read Mode.

7/20

Share Link: