CDB5364 Ver la hoja de datos (PDF) - Cirrus Logic

Número de pieza

componentes Descripción

Fabricante

CDB5364

Evaluation Board for CS5364

Cirrus Logic 

CDB5364

4.5 Power Supply Circuitry

Power is applied to the evaluation board through five binding posts (+5 V, +12 V, -12 V, VA and GND). The

GND connection is the common reference for power supplies. The +5 V binding post supplies digital power

for all logic devices. The +12 V and -12 V binding posts supply power for the Operational Amplifier input

buffers. The VA binding posts supplies power to the Analog Reference.

4.6 Grounding and Power Supply Treatment

As a high-peformance mixed-signal device, the CS5364 requires careful attention to power and grounding

arrangements to optimize CS5364 performance. The CDB5364 Evaluation Board provides an excellent ref-

erence example of an optimum two-layer board layout that places decoupling capacitors as close to the

CS5364 as possible and provides ground plane fill on both top and bottom layers.

4.7 FPGA Hardware

The on-board FPGA is utilized for several purposes. In addition to providing a method for configuring the

CS5364 in Software mode, it contains its own configuration registers that provide clock and data routing for

Master and Slave modes of the CS5364. The FPGA contains a multiplexer that selects which SDOUT line

is routed to the CS8406. It also contains a TDM2PCM engine that extracts channel pairs from a TDM stream

and sends them to the CS8406.

4.8 CS8406 S/PDIF Audio Transmitter

The system generates standard S/PDIF data using a CS8406 192 kHz Digital Audio Transmitter. The

CS8406 receives input data from the FPGA in PCM format and transmits S/PDIF data on both optical and

coaxial output connectors. The optical output connector is limited to a maximum speed of 96 kHz. The co-

axial connector supports Quad Speed 192 kHz clocking rates.

4.9 Serial Audio Interface

In addition to the standard S/PDIF outputs, the Customer Evaluation Board has been designed to allow

Master and Slave operation using the Serial Audio Interface (SAI) via the 14-pin header, J4, which includes

the signals MCLK, SCLK, LRCK, and the four serial data lines.

When the CS5364 is in Slave mode, SCLK and LRCK/FS must be supplied externally through the J4 head-

er.

4.10 Analog Input Buffer

The CDB5364 includes an example of an active low-noise, single-ended-to-differential analog input buffer

shown in the schematic drawings, Figures 10 and 11. Alternate active or passive, single-ended or differen-

tial topologies may be used as cost dictates. However, the high performance of the CS5364 may be com-

promised. Optimum device performance is met by buffering the CS5364 with a low noise structure that is

stable with a 2700 pF output load.

DS625DB1

11

Share Link: