SCA-5 Ver la hoja de datos (PDF) - Sirenza Microdevices => RFMD
Número de pieza
componentes Descripción
Fabricante
SCA-5 Datasheet PDF : 3 Pages
| |||
Preliminary
SCA-5 DC-3 GHz Cascadable MMIC Amplifier
Absolute Maximum Ratings
Parameter
Absolute Limit
Max. Device Current (ID)
Max. Device Voltage (VD)
Max. RF Input Power
75 mA
6V
+20 dBm
Max. Junction Temp. (TJ)
Operating Temp. Range (TL)
Max. Storage Temp.
+150°C
-40°C to +85°C
+150°C
Operation of this device beyond any one of these limits may
cause permanent damage. For reliable continous operation,
the device voltage and current must not exceed the maximum
operating values specified in the table on page one.
Bias Conditions should also satisfy the following expression:
IDVD < (TJ - TL) / RTH, j-l
Typical Biasing Configuration
Recommended Bias Resistor Values
Supply Voltage
(Vs)
5V 7.5V 9V 12V 15V 20V
Rbias (Ohms) 20 70 100 160 220 320
Mounting Instructions
The data shown was taken on a 31mil thick FR-4 board with
1 ounce of copper on both sides.
The board was mounted to a baseplate with 3 screws as
shown. The screws bring the top side copper temperature
to the same value as the baseplate.
1. Use 1 or 2 ounce copper, if possible.
2. Solder the copper pad on the backside of the device
package to the ground plane.
3. Use a large ground pad area with many plated through-
holes as shown.
4. If possible, use at least one screw no more than 0.2 inch
from the device package to provide a low thermal resis-
tance path to the baseplate of the package.
5. Thermal resistance from ground lead to screws is
2 deg. C/W.
SCA-5
Pin Designation
1
RF in
2
GND
3
RF out and
Bias
4
GND
Outline Drawing
1
2
4
3
522 Almanor Ave., Sunnyvale, CA 94085
Phone: (800) SMI-MMIC
3
http://www.sirenza.com
EDS-102420 Rev A
Share Link: 