EM78860 Ver la hoja de datos (PDF) - ELAN Microelectronics

Número de pieza

componentes Descripción

Fabricante

EM78860

8-BIT MICRO-CONTROLLER

ELAN Microelectronics 

EM78860

8-BIT MICRO-CONTROLLER

FUNCTION DESCRIPTION

Operational Registers

R0 (Indirect Addressing Register)

R0 is not a physically implemented register. It is useful as indirect addressing pointer. Any instruction using

R0 as register actually accesses data pointed by the RAM Select Register (R4).

R1 (TCC)

• Increased by an internal signal edge applied to TCC , or by the instruction cycle clock.

• Written and read by the program as any other register.

R2 (Program Counter)

• The structure is depicted in Fig. 4.

• Generates 16Kx13 on-chip ROM addresses to the relative programming instruction codes.

• ”JMP” instruction allows the direct loading of the low 10 program counter bits.

• “CALL” instruction loads the low 10 bits of the PC, PC+1, and then push into the stack..

• “RET’’ (“RETL k”, “RETI”) instruction loads the program counter with the contents at the top of stack.

• ”MOV R2,A” allows the loading of an address from the A register to the PC, and the ninth and tenth bits are

cleared to “0'’.

• “ADD R2,A” allows a relative address be added to the current PC, and contents of the ninth and tenth bits are

cleared to “0'’.

• “TBL” allows a relative address be added to the current PC, and contents of the ninth and tenth bits don’t

change.

• The most significant bit (A10~A13) will be loaded with the content ofbit PS0~PS3 in the status register (R5)

upon the execution of a “JMP’’, “CALL’’, “ADD R2,A’’, or “MOV R2,A’’ instruction.

PC A13 A12 A11 A10 A9 A8

A7~A0

0000 PAGE0 0000~03FF

0000 PAGE1 0400~07FF

0000 PAGE3 0800~0BFF

CALL

RET

RETTL

RETI

Stack 1

Stack 2

Stack 3

Stack 4

Stack 5

Stack 6

Stack 7

Stack 8

1110 PAGE14 3800~3BFF

1111 PAGE15 3C00~3FFF

Fig.4 Program counter organization

* This specification are subject to be changed without notice.

6.24.1998 4

Share Link: