SNAD02C Ver la hoja de datos (PDF) - Sonix Technology Co., Ltd

Número de pieza

componentes Descripción

Fabricante

SNAD02C

8-CHANNEL 10-BIT ADC

Sonix Technology Co., Ltd 

SNAD02C

8-CHANNEL 10-BIT ADC

Name

Function

PH Set the pull-up resistor of the channel in digital input mode. 1:ON, 0:OFF.

PL Set the pull-down resistor of the channel in digital input mode.

“1”: ON, “0”: OFF.

RF, MB Set the reference source (from internal bandgap or “REF” pin)

RF=0, MB=1: reference voltage from “REF” pin

RF=1, MB=0: reference voltage from internal bandgap

Table-3

Note:

1. The condition of both PH=1 and PL=1 is prohibited.

2. Pull-up and pull-down resistors are not activated while the corresponding channel is set as

analog input mode.

3. Before into power down mode, the “RF” and “MB” register must set up “0”, otherwise the standby

current will more than 1uA.

6.4. ADC Read Timing

START

CLK

ADC Reading

DIO

HiZ

CM2 CM1 CM0 ID2 ID1 ID0 X

X D9 D8 D7 D6 D5 D4 D3 D2 D1 D0

Port Input

Port Output

Figure-6 The timing diagram of ADC reading

Version: 1.3

8

July 31, 2003

Share Link: