DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MF601G2-02BJ Ver la hoja de datos (PDF) - MITSUBISHI ELECTRIC

Número de pieza
componentes Descripción
Fabricante
MF601G2-02BJ
Mitsubishi
MITSUBISHI ELECTRIC  Mitsubishi
MF601G2-02BJ Datasheet PDF : 18 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Preliminary
Signal Description
Signal Name
Address bus[DA2-DA0]
Data bus[D15-D0]
Chip select[CS0#, CS1#]
Drive I/O read[DIOR#]
Drive I/O write[DIOW#]
DMA acknowledge[DMACK#]
DMA request[DMARQ]
Drive interrupt[INTRQ]
Drive 16-bit I/O[IOCS16#]
Drive active/drive1 present[DASP#]
Drive reset[RESET#]
I/O channel ready[IORDY]
Passed diagnostics[PDIAG#]
Cable select[CSEL]
VDD
GND
MITSUBISHI STORAGE CARD
MF6XXXX-02BJXX series
FLASH DRIVES
I/O
Pin No.
Description
I 36, 33, 35
Signals DA2-DA0 are address bus. DA2 is the MSB
and DA0 is the LSB.
I/O 18, 16, 14, 12, Signals DD15-DD0 are data bus.
10, 8, 6, 4, 3, 5,
7, 9, 11, 13, 15,
17
I 37, 38
I 25
CS0# is used to select the Command Block
Registers. CS1# is used to select the Control Block
Registers.
DIOR# is used to read data from the Drive’s I/O space.
I 23
DIOW# is used to write data to the Drive’s I/O space.
I 29
This signal shall be used by the host in response to
DMARQ to either acknowledge that data has been
accepted, or that data is available.
O 21
This signal, used for DMA data transfer between host
and drive, shall be asserted by the drive when it is
ready to transfer data to or from the host.
O 31
O 32
I/O 39
This signal is active high interrupt request to the host.
This output signal is asserted when the I/O port
address is capable of 16-bit access.
This signal is the DISK Active/Slave Present signal in
the Master/Slave handshake protocol.
I1
This input pin is the active low hardware reset from the
host.
O 27
This signal is asserted to delay completion of the
memory or I/O access cycle.
I/O 34
This signal is the Pass Diagnostic signal in the
Master/Slave handshake protocol.
I 28
This signal is used to configure this Drive as a Master
or a Slave. When this signal is grounded, this Drive is
configured as a Master. When this signal is Open, this
Drive is configure as a Slave.
- 41, 42
5V power.
- 2, 19, 22, 24, Ground.
26, 30, 40, 43,
44
MITSUBISHI
ELECTRIC
4/18
Oct.2000. Rev. 0.3

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]