Product Specification
CPF127F
4.2.3. DC characteristic :
All requirement of this specification can be met in the presence of all POTS loop
currents from 0mA to 80mA. This POTS splitter can pass POTS tip-to-ring dc voltages
of 0V to 72V and ringing signals of 40V to 80Vrms at any frequency from22Hz to 28Hz
with a dc component in the range from 0V to 72V. The dc resistance from tip-to-ring at
the line port interface with the phone interface shorted, shall be less than or equal to
12.5 ohms. The DC resistance from tip-to-ground and from ring-to-ground at the POTS
interface with the U-R interface open shall be greater than or equal to 5 Megohms. The
ground point shall be local building or green wire ground. As an objective , the dc
resistance should exceed 10MΩ.
4.3. Test Methodology :
4.3.1. Insertion and Return loss Test For ISDN Function.
4.3.1.1. Test Equipment :
a . HP4395A Network / Spectrum / Impedance Analyzer
b . HP87512A Transmission / Reflection test set
c . Balun North Hills : 0303LB( 50Ω : 150Ω )
4.3.1.2. Test Setup: is shown in Fig.1 .
4.3.1.3. Test Procedure :
a . Set HP4395A in B/R mode for attenuation test while in A/R mode for Return loss
test.
b . Connecting the Analyzer to the ISDN and line side of splitter through the North
Hills Balun 0303LB
c . Set frequency of interest given in specification.
d . Calibrating the HP4395A network Analyzer via the thru for attenuation test while
open, load calibration being performed for Return loss.
e . Measurement attenuation and Return loss.
Fig.1. Test Setup
Data sheet subject to change without notice
20.89nF
82uH
100ohm
Fig. 1-a ZADSL-I does not include the
blocking capacitors CB .
RDPS-POTS485(R0)03/28/2003
SHEET 7 OF 10