MIC5016 Ver la hoja de datos (PDF) - Micrel
Número de pieza
componentes Descripción
Fabricante
MIC5016 Datasheet PDF : 12 Pages
| |||
MIC5016/5017
10µF
1/2 MIC5017
V+
Input
Source
Gnd Gate
1kΩ
12V
On
RS
0.06Ω
R4
1kΩ
R1
1kΩ
1000pF
12V
LM3905N
1 Trigger Logic 8
2
VREF
Emit 7
3 R/C
Coll 6
4 Gnd
V+ 5
0.01µF
R2 LM301A
120kΩ
2.2kΩ
Micrel
Figure 5. High Side Driver with Delayed Overcurrent Shutdown
Typical Applications
Variable Supply Low Side Driver for Motor Speed Control
(Figure 6) The internal regulation in the MIC5016/17 allows
a steady gate enhancement to be supplied while the MIC5016/
17 supply varies from 5V to 30V, without damaging the
internal gate to source zener clamp. This allows the speed of
the DC motor shown to be varied by varying the supply
voltage.
VCC = +5V to +30V
1/2 MIC5017
V+
M
ON
Input
OFF
Source
Gnd Gate
IRF540
Figure 6: DC Motor Speed Control/Driver
applications, it is acceptable to allow this voltage to momen-
tarily turn the MOSFET back on as a way of dissipating the
inductor's current. However, if this occurs when driving a
solenoid valve with a fast switching speed, chemicals or
gases may inadvertantly be dispensed at the wrong time with
possibly disasterous consequences. Also, too large of a
kickback voltage (as is found in larger solenoids) can damage
the MIC5016 or the power FET by forcing the Source node
below ground (the MIC5016 can be driven up to 20V below
ground before this happens). A catch diode has been
included in this design to provide an alternate route for the
inductive kickback current to flow. The 5kΩ resistor in series
with this diode has been included to set the recovery time of
the solenoid valve.
24V
1/2 MIC5016
V+
ON
Input
OFF
Source
Gnd
Gate
IRFZ40
Solenoid Valve Driver (Figure 7) High power solenoid valves
are used in many industrial applications requiring the timed
dispensing of chemicals or gases. When the solenoid is
activated, the valve opens (or closes), releasing (or stopping)
fluid flow. A solenoid valve, like all inductive loads, has a
considerable “kickback” voltage when turned off, as current
cannot change instantaneously through an inductor. In most
ASCO
8320A
Solenoid
1N4005
5kΩ
Figure 7: Solenoid Valve Driver
October 1998
7
MIC5016/5017
Share Link: 