MSM6665-XX Ver la hoja de datos (PDF) - Oki Electric Industry

Número de pieza

componentes Descripción

Fabricante

MSM6665-XX

DOT MATRIX LCD CONTROLLER WITH 17-DOT COMMON DRIVER AND 80-DOT SEGMENT DRIVER

Oki Electric Industry 

¡ Semiconductor

MSM6665-xx

• CHB (Character Blink on/off)

[0,X,X,X,0,0,1/0,X]

Command used to control blinking of characters and arbitrator (5-dot unit).

This command is executed to the address indicated by the address pointer. Blinking is

on by setting D1="1", and off by setting D1="0".

For blinking of characters, all lighting-on or all lighting-off, and characters-displaying

are repeated.

Choosing between all lighting-on and all lighting-off is controlled by BPC command.

For arbitrator, only lighting bits repeat lighting-off or lighting-off. The blink control or

arbitrator is valid only when ABBC1/5="0" and in the 5-dot unit mode.

Refer to "BPC".

• CSC (Cursor Control on/off)

[0,X,X,X,0,1,1/0,X]

Command used to control lighting-on and lighting-off of cursor.

This command is executed to the address indicated by the address pointer.The cursor

is lighting on by setting D1="1", and lighting off by setting D1="0".

• CSB (Cursor Blink on/off)

[0,X,X,X,0,1,1/0,X]

Command used to control blinking of cursor.

This command is executed to the address indicated by the address pointer. Blinking is

on by setting D1="1", and off by setting D1="0".

The blinking in the address, where cursor-lighting-on is not specified, does not occur,

though the command of blinking is acceptable. Blinking starts by specifying cursor-

lighting-on.

• CCB (Character & Cursor Blink on/off)

[0,X,X,X,1,1,1/0,X]

Command used to execute both CHB command and CSB command.

• BPC (Blink Pattern Control)

[1,0,0,X,0,0,1,1/0]

Command used to control blink patterns of characters.

When D0="1" is set, all lighting-off (35 dots) and characters-displaying are repeated.

When D0="0" is set, all lighting-on (35 dots) and characters-displaying are repeated.

When D0="1" is set, if characters are blank, their blinkings do not occur in appearance.

When D0="0" is set, if characters are in all lighting-on, their blinkings do not occur in

appearance.

D0 is set to "0" affer inputting Reset.

[D0 = "1"]

[D0 = "0"]

• Increment (+1) in address pointer

When display data or arbitrator data (1-dot unit) is entered or when the following

commands are executed, the address pointer is incremented by 1.

AINC, CHB, CSC, CSB and CCB.

14/30

Share Link: