ADADC85S12 Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

ADADC85S12

Fast, Complete 12-Bit A/D Converters

Analog Devices 

AD ADC84/AD ADC85

CLOCK RATE CONTROL ALTERNATE

CONNECTIONS

If adjustment of the CLOCK RATE is desired for faster conver-

sion speeds, the CLOCK RATE CONTROL may be connected

to an external multiturn trim potentiometer with a TCR of

±100 ppm/°C or less as shown in Figure 14 and Figure 15. If the

potentiometer is connected to –15 V, conversion time can be

increased as shown in Figure 5. If these adjustments are used,

delete the connections shown in Table 2 for Pin 17. See Figure 2

for nonlinearity error versus conversion speed and Figure 5 for

the effect of the control voltage on clock speed.

Figure 14. 12-Bit Clock Rate Control Optional Fine Adjust

significant bits in one byte and the 4 LSBs in the high nibble of

another byte. The data now represents the fractional binary

number relating the analog signal to the full-scale voltage. An

advantage to this organization is that the most-significant eight

bits can be read by the processor as a coarse indication of the

true signal value. The full 12-bit word can then be read only

when all 12 bits are needed. This allows faster and more

efficient control of a process.

Figure 16 shows a typical connection of 8085-type bus, using a

left-justified data format for unipolar inputs. Status polling is

optional, and can be read simultaneously with the 4LSBs. If it is

desired to right-justify the data, pins 1 through 12 of the

ADADC84/AD ADC85 should be reversed, as well as the

connections to the data bus high and low byte address signals.

When dealing with bipolar inputs (±5V, ±10V ranges), using the

MSB directly yields a complementary offset binary-coded

output. If complementary twos complement coding is desired, it

can be produced be substituting MSB (Pin 13) for the MSB.

This facilitates the arithmetic operation which are subsequently

performed on the ADC output data.

Figure 15. 8-Bit Clock Rate Control Optional Fine Adjust

MICROPROCESSOR INTERFACING

The fast conversion times of the AD ADC84/AD ADC85

suggests several methods of interface to microprocessors. In

systems where the ADC is used for high sampling rates on a

single signal which is to be digitally processed, CPU-controlled

conversion may be inefficient due to the slow cycle times of

most microprocessors. It is generally preferable to perform

conversions independently, inserting the resultant digital data

directly into memory. This can be done using direct memory

access (DMA), which is totally transparent to the CPU. Interface

to user-designed DMA hardware is facilitated by the guaranteed

data validity on the falling edge of the EOC signal.

Clearly, 12 bits of data must be broken up for interface to a 8-bit

wide data bus. There are two possible formats: right-justified

and left-justified. In a right-justified system, the least significant

8 bits occupy one byte and the four MSBs reside in the low

nibble of another byte. This format is useful when the data from

the ADC is being treated as a binary number between 0 and

4095. The left-justified format supplies the eight most-

Figure 16. AD ADC84/AD ADC85 – 8085A Interface Connections

Rev. B | Page 10 of 12

Share Link: