M27C1001-20XF1X Ver la hoja de datos (PDF) - STMicroelectronics
Número de pieza
componentes Descripción
Fabricante
M27C1001-20XF1X Datasheet PDF : 17 Pages
| |||
M27C1001
Table 8B. Read Mode AC Characteristics (1)
(TA = 0 to 70°C, –40 to 85°C or –40 to 125°C; VCC = 5V ± 5% or 5V ± 10%; VPP = VCC)
M27C1001
Symbol Alt
Parameter
Test Condition
-80
-90
-10
-12/-15/
-20/-25
Unit
Min Max Min Max Min Max Min Max
tAVQV
tACC
Address Valid to
Output Valid
E = VIL, G = VIL
80
90
100
120 ns
tELQV
tCE
Chip Enable Low to
Output Valid
G = VIL
80
90
100
120 ns
tGLQV
tOE
Output Enable Low
to Output Valid
E = VIL
40
45
50
60 ns
tEHQZ (2)
tDF
Chip Enable High to
Output Hi-Z
G = VIL
0 30 0 30 0 30 0 40 ns
tGHQZ (2)
tDF
Output Enable High
to Output Hi-Z
E = VIL
0 30 0 30 0 30 0 40 ns
tAXQX
tOH
Address Transition
to Output Transition
E = VIL, G = VIL
0
0
0
0
ns
Note: 1. VCC must be applied simultaneously with or before VPP and removed simultaneously or after VPP.
2. Sampled only, not 100% tested.
Figure 5. Read Mode AC Waveforms
A0-A16
E
G
Q0-Q7
VALID
tAVQV
tGLQV
tELQV
tAXQX
VALID
tEHQZ
tGHQZ
Hi-Z
AI00713B
System Considerations
The power switching characteristics of Advanced
CMOS EPROMs require careful decoupling of the
devices. The supply current, ICC, has three seg-
ments that are of interest to the system designer:
the standby current level, the active current level,
and transient current peaks that are produced by
the falling and rising edges of E. The magnitude of
the transient current peaks is dependent on the
capacitive and inductive loading of the device at
the output. The associated transient voltage peaks
can be suppressed by complying with the two line
output control and by properly selected decoupling
capacitors. It is recommended that a 0.1µF ceram-
ic capacitor be used on every device between VCC
and VSS. This should be a high frequency capaci-
tor of low inherent inductance and should be
placed as close to the device as possible. In addi-
tion, a 4.7µF bulk electrolytic capacitor should be
used between VCC and VSS for every eight devic-
es. The bulk capacitor should be located near the
power supply connection point. The purpose of the
bulk capacitor is to overcome the voltage drop
caused by the inductive effects of PCB traces.
6/17
Share Link: 