74ALVCH16823DGG Ver la hoja de datos (PDF) - NXP Semiconductors.

Número de pieza

componentes Descripción

Fabricante

74ALVCH16823DGG

18-bit bus-interface D-type flip-flop with reset and enable; 3-state

NXP Semiconductors. 

74ALVCH16823

18-bit bus-interface D-type flip-flop with reset and enable;

3-state

Rev. 3 — 1 February 2018

Product data sheet

1 General description

The 74ALVCH16823 is a 18-bit edge-triggered flip-flop featuring separate D-type inputs

for each flip-flop and 3-state outputs for bus oriented applications. Incorporates bushold

data inputs which eliminate the need for external pull-up resistors to hold unused inputs.

The 74ALVCH16823 consists of two sections of nine edge-triggered flip-flops. A clock

(nCP) input, an output-enable (nOE) input, a master reset (nMR) input and a clock-

enable (nCE) input are provided for each total 9-bit section.

With the clock-enable (nCE) input LOW, the D-type flip-flops will store the state of

their individual nDn-inputs that meet the set-up and hold time requirements on the

LOW-to-HIGH nCP transition. Taking nCE HIGH disables the clock buffer, thus latching

the outputs. Taking the master reset (nMR) input LOW causes all the nQn outputs to go

LOW independently of the clock.

When nOE is LOW, the contents of the flip-flops are available at the outputs. When the

nOE is HIGH, the outputs go to the high impedance OFF-state. Operation of the nOE

input does not affect the state of flip-flops.

Active bus hold circuitry is provided to hold unused or floating data inputs at a valid logic

level.

2 Features and benefits

• Wide supply voltage range from 1.2 V to 3.6 V

• CMOS low-power consumption

• Direct interface with TTL levels

• Current drive ± 24 mA at 3.0 V

• MULTIBYTE flow-through standard pin-out architecture

• Low inductance multiple VCC and GND pins for minimum noise and ground bounce

• Output drive capability 50 Ω transmission lines at 85°C

• All data inputs have bushold

• Complies with JEDEC standard no. 8-1A

• Complies with JEDEC standards:

– JESD8-5 (2.3 V to 2.7 V)

– JESD8B/JESD36 (2.7 V to 3.6 V)

• ESD protection:

– HBM ANSI/ESDA/JEDEC JS-001 exceeds 2000 V

– CDM JESD22-C101E exceeds 1000 V

Share Link: