ADE7755AN-REF Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

ADE7755AN-REF

Energy Metering IC with Pulse Output

Analog Devices 

ADE7755

Parameter

Specifications Unit

Test Conditions/Comments

POWER SUPPLY

AVDD

DVDD

AIDD

DIDD

For Specified Performance

4.75

V min

5 V – 5%

5.25

V max

5 V + 5%

4.75

V min

5 V – 5%

5.25

V max

5 V + 5%

3

mA max Typically 2 mA

2.5

mA max Typically 1.5 mA

NOTES

1See Terminology section for explanation of specifications.

2See Plots in Typical Performance Graphs.

3Sample tested during initial release and after any redesign or process change that may affect this parameter.

Specifications subject to change without notice.

TIMING CHARACTERISTICS1, 2 (AVDD = DVDD = 5 V ؎ 5%, AGND = DGND = 0 V, On-Chip Reference, CLKIN = 3.58 MHz, TMIN to

TMAX = –40؇C to +85؇C.)

Parameter Specifications Unit Test Conditions/Comments

t13

275

ms

F1 and F2 Pulsewidth (Logic Low)

t2

See Table III

sec

Output Pulse Period. See Transfer Function section.

t3

1/2 t2

sec

Time between F1 Falling Edge and F2 Falling Edge

t43, 4

90

ms

CF Pulsewidth (Logic High)

t5

See Table IV

sec

CF Pulse Period. See Transfer Function section.

t6

CLKIN/4

sec

Minimum Time between F1 and F2 Pulse

NOTES

1Sample tested during initial release and after any redesign or process change that may affect this parameter.

2See Figure 1.

3The pulsewidths of F1, F2, and CF are not fixed for higher output frequencies. See Frequency Outputs section.

4The CF pulse is always 18 ms in the high-frequency mode. See Frequency Outputs section and Table IV.

Specifications subject to change without notice.

ABSOLUTE MAXIMUM RATINGS*

(TA = 25∞C unless otherwise noted.)

AVDD to AGND . . . . . . . . . . . . . . . . . . . . . . . –0.3 V to +7 V

DVDD to DGND . . . . . . . . . . . . . . . . . . . . . . . –0.3 V to +7 V

DVDD to AVDD . . . . . . . . . . . . . . . . . . . . . . –0.3 V to +0.3 V

Analog Input Voltage to AGND

V1P, V1N, V2P, and V2N . . . . . . . . . . . . . . . –6 V to +6 V

Reference Input Voltage to AGND . . –0.3 V to AVDD + 0.3 V

Digital Input Voltage to DGND . . . –0.3 V to DVDD + 0.3 V

Digital Output Voltage to DGND . . –0.3 V to DVDD + 0.3 V

Operating Temperature Range

Industrial . . . . . . . . . . . . . . . . . . . . . . . . . . –40∞C to +85∞C

Storage Temperature Range . . . . . . . . . . . . –65∞C to +150∞C

Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . 150∞C

24-Lead SSOP, Power Dissipation . . . . . . . . . . . . . . 450 mW

qJA Thermal Impedance . . . . . . . . . . . . . . . . . . . . 112∞C/W

Lead Temperature, Soldering

Vapor Phase (60 sec) . . . . . . . . . . . . . . . . . . . . . . 215∞C

Infrared (15 sec) . . . . . . . . . . . . . . . . . . . . . . . . . . . 220∞C

*Stresses above those listed under Absolute Maximum Ratings may cause perma-

nent damage to the device. This is a stress rating only; functional operation of the

device at these or any other conditions above those listed in the operational

sections of this specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect device reliability.

ORDERING GUIDE

Model

Package Description

Package Options

ADE7755ARS

ADE7755ARSRL

ADE7755AN-REF

EVAL-ADE7755EB

Shrink Small Outline Package

RS-24

Shrink Small Outline Package in Reel

RSRL-24

ADE7755 Reference Design PCB (See AN-559)

ADE7755 Evaluation Board

CAUTION

ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily

accumulate on the human body and test equipment and can discharge without detection. Although

the ADE7755 features proprietary ESD protection circuitry, permanent damage may occur on

devices subjected to high-energy electrostatic discharges. Therefore, proper ESD precautions are

recommended to avoid performance degradation or loss of functionality.

REV. 0

–3–

WARNING!

ESD SENSITIVE DEVICE

Share Link: