LTC485I(RevE) Ver la hoja de datos (PDF) - Linear Technology

Número de pieza

componentes Descripción

Fabricante

LTC485I
(Rev.:RevE)

Low Power RS485 Interface Transceiver

Linear Technology 

UU W U

APPLICATIO S I FOR ATIO

Basic Theory of Operation

Previous RS485 transceivers have been designed using

bipolar technology because the common-mode range of

the device must extend beyond the supplies and the device

must be immune to ESD damage and latchup. Unfortu-

nately, the bipolar devices draw a large amount of supply

current, which is unacceptable for the numerous applica-

tions that require low power consumption. The LTC485 is

the first CMOS RS485/RS422 transceiver which features

ultra-low power consumption without sacrificing ESD and

latchup immunity.

The LTC485 uses a proprietary driver output stage, which

allows a common-mode range that extends beyond the

power supplies while virtually eliminating latchup and

providing excellent ESD protection. Figure 9 shows the

LTC485 output stage while Figure 10 shows a conven-

tional CMOS output stage.

When the conventional CMOS output stage of Figure 10

enters a high impedance state, both the P-channel (P1)

and the N-channel (N1) are turned off. If the output is then

driven above VCC or below ground, the P + /N-well diode

LTC485

(D1) or the N + /P-substrate diode (D2) respectively will

turn on and clamp the output to the supply. Thus, the

output stage is no longer in a high impedance state and is

not able to meet the RS485 common-mode range require-

ment. In addition, the large amount of current flowing

through either diode will induce the well known CMOS

latchup condition, which could destroy the device.

The LTC485 output stage of Figure 9 eliminates these

problems by adding two Schottky diodes, SD3 and SD4.

The Schottky diodes are fabricated by a proprietary modi-

fication to the standard N-well CMOS process. When the

output stage is operating normally, the Schottky diodes

are forward biased and have a small voltage drop across

them. When the output is in the high impedance state and

is driven above VCC or below ground, the parasitic diodes

D1 or D2 still turn on, but SD3 or SD4 will reverse bias and

prevent current from flowing into the N-well or the sub-

strate. Thus, the high impedance state is maintained even

with the output voltage beyond the supplies. With no

minority carrier current flowing into the N-well or sub-

strate, latchup is virtually eliminated under power-up or

power-down conditions.

LOGIC

VCC

SD3

P1

D1

OUTPUT

SD4

N1

D2

LTC485 • F09

Figure 9. LTC485 Output Stage

LOGIC

VCC

P1

D1

OUTPUT

N1

D2

LTC485 • F10

Figure 10. Conventional CMOS Output Stage

7

Share Link: