DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

SMCJ10 Ver la hoja de datos (PDF) - MERITEK ELECTRONICS CORPORATION

Número de pieza
componentes Descripción
Fabricante
SMCJ10
MERITEK
MERITEK ELECTRONICS CORPORATION MERITEK
SMCJ10 Datasheet PDF : 4 Pages
1 2 3 4
Transient 9ROWDJH6XSSUHVVRUV
SMCJ Series
MERITEK
FEATURES
For surface mounted applications in order to optimize board space.
Low profile package.
Built-in strain relief.
Glass passivated junction.
Low inductance.
Excellent clamping capability.
Repetition Rate (duty cycle): 0.05%.
Fast response time: typically less than 1.0ps from 0 volt to BV min.
Typical IR less than 1μA above 10V.
High Temperature soldering: 260°C/10 seconds at terminals.
Plastic package has Underwriters Laboratory Flammability 94V-O.
MECHANICAL DATA
M Case: JEDEC DO-20114AMBo.ldMeodldPeldasptliac.stic over glass passivated junction.
Terminals: :SAoxldiaelrlepaladtse,ds, oslodledrearbalbelepeprerMMILI-LS-STDTD-7-5705,0M, Metehtohdod2022062.6.
Polarity: Color abnadnddedneontoetsesscatthode except Bidpiorelacrt.ional.
MStoaunndtainrdg Paocskitaiognin: gA:n1y.2mm tape (EIA STD RS-481).
Weight: 0.007 ounce, 0.21 grams.
UL E223045
SMC/DO-214AB
DEVICES FOR BIPOLAR APPLICATION
For Bidirectional use C or CA suffix for type SMCJ5.0 through type SMCJ440 (e.g. SMCJ5.0CA, SMCJ440CA);
Electrical characteristics apply in both directions.
MAXIMUM RATINGS CHARACTERISTICS
Ratings at 25ć ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
P eak Pulse Power Dissipation on 10/1000ȝs waveform. (Note 1, Note 2, Fig. 1)
Peak Pulse Current on 10/1000ȝs waveform. (Note 1,Fig. 3)
Steady State Power Dissipation at TL =75ćˈLead length .375” (9.5mm).
(Note 2, Fig. 5)
Peak Forward Surge Currentˈ8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 3, Fig. 6)
Operating junction and Storage Temperature Range.
PPPM
IPPM
PM(AV)
IFSM
TJ , TSTG
Minimum 1,500
See Table
6.5
200
-65 to +150
Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25ć per Fig. 2.
N 2. Mounted on 0.8mm x 0.8mm Copper Pads to each terminal.
3. 8.32ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
.
UNIT
Watts
Amps
Watts
Amps
ć
All specifications are subject to change without notice.
1
Rev 7

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]