IN24LC08B Ver la hoja de datos (PDF) - IK Semicon Co., Ltd
Número de pieza
componentes Descripción
Fabricante
IN24LC08B Datasheet PDF : 10 Pages
| |||
Figure 11. Sequential read
IN24LC04B/08B
PIN DESCRIPTIONS
SPA Serial Address/Data Input/Output
This is a bidirectional pin used to transfer addresses and data into and data out of the device. It is an
open drain terminal, therefore the SDA bus requires a puliup resistor to Vcc (typical 10KΩ for 100
kHz, 1 KΩ for 400 kHz).
For normal data transfer SDA is allowed to change only during SCL low. Changes during SCL high
are reserved for indicating the START and STOP conditions.
SCL Serial Clock
This input is used to synchronize the data transfer from and to the device.
WP
This pin must be connected to either Vss or Vcc.
If tied to Vss, normal memory operation is enabled (read/write the entire memory).
If tied to Vcc, WRITE operations are inhibited. The entire memory will be write-protected. Read
operations are not affected.
This feature allows the user to use the IN24LC04B/08B as a serial ROM when WP is enabled (tied
to Vcc).
A0,A1,A2
These pins are not used by the IN24LC04B/08B. They may be left floating or tied to either Vss or
Vcc.
9
Share Link: 