airFiber Configuration
airFiber Configuration
The instructions in this section explain how to access the airFiber
Configuration Interface and configure the following settings:
• Wireless Mode Configure one airFiber radio as the Master and
the other as the Slave.
• Duplex The airFiber radio supports both half-duplex and
full‑duplex operation. Half-duplex operation provides more
frequency planning options at the cost of higher latency
and throughput. Full-duplex operation provides the highest
throughput and lowest latency; however, you have fewer
frequency management options.
-- Half Duplex (default) The TX and RX Frequencies can be the
same or different to suit local interference.
RX
RX
Frequency A
Frequency A
TX
Master
TX
Slave
Half-Duplex Diagram
-- Full Duplex The TX and RX Frequencies should be different.
RX
RX
Frequency A
Frequency B
TX
Master
TX
Slave
Full-Duplex Diagram
• TX and RX Frequencies The TX Frequency on the Master must
match the RX Frequency on the Slave, and vice versa.
9