MP1482 Ver la hoja de datos (PDF) - Monolithic Power Systems
Número de pieza
componentes Descripción
Fabricante
MP1482 Datasheet PDF : 12 Pages
| |||
MP1482 – 2A, 18V SYNCHRONOUS RECTIFIED, STEP-DOWN CONVERTER
OPERATION
FUNCTIONAL DESCRIPTION
The MP1482 is a synchronous rectified,
current-mode, step-down regulator. It regulates
input voltages from 4.75V to 18V down to an
output voltage as low as 0.923V, and supplies
up to 2A of load current.
The MP1482 uses current-mode control to
regulate the output voltage. The output voltage
is measured at FB through a resistive voltage
divider and amplified through the internal
transconductance error amplifier. The voltage at
the COMP pin is compared to the switch current
measured internally to control the output
voltage.
The converter uses internal N-Channel
MOSFET switches to step-down the input
voltage to the regulated output voltage. Since
the high side MOSFET requires a gate voltage
greater than the input voltage, a boost capacitor
connected between SW and BS is needed to
drive the high side gate. The boost capacitor is
charged from the internal 5V rail when SW is low.
When the MP1482 FB pin exceeds 20% of the
nominal regulation voltage of 0.923V, the over
voltage comparator is tripped and the COMP
pin and the SS pin are discharged to GND,
forcing the high-side switch off.
FB
SS
COMP
EN
+
1.1V --
+
0.3V --
--
+
0.923V +
OVP
RAMP
OSCILLATOR
340KHz
CLK
ERROR
AMPLIFIER
CURRENT
SENSE
AMPLIFIER +
--
+
SQ
RQ
--
CURRENT
COMPARATOR
IN
5V
BS
SW
--
2.5V +
+
EN OK
LOCKOUT
COMPARATOR
1.2V
1.5V --
SHUTDOWN
COMPARATOR
Figure 1—Functional Block Diagram
OVP
IN < 4.1V
IN
INTERNAL
REGULATORS
GND
MP1482 Rev. 1.31
www.MonolithicPower.com
6
7/9/2012
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2012 MPS. All Rights Reserved.
Share Link: 