501930-1200 Ver la hoja de datos (PDF) - Molex Connectors

Número de pieza

componentes Descripción

Fabricante

501930-1200

HAND CRIMP TOOL & Terminal Series

Molex Connectors 

Hand Crimp Tool For 1.25mm (.049") Pitch Crimp Terminals

How to Adjust Tool Preload (See

Figure 12)

This hand tool is factory preset to 25-45

LBS. preload. It may be necessary over

the life of the tool to adjust tool handle

preload force. Listed below are the steps

required to adjust the crimping force of the

hand tool to obtain proper crimp

conditions:

SQUEEZE

THE LINK IN

RATCHET

THE HANDLE

RELEASE LEVER

HOLD THE HAND

TOOL IN POSITION

1. Hold the hand tool in the palm of your

hand as shown in Figure 10. Using

Figure 12

the index finger squeeze the link

towards the top of the hand tool

frame. This will release the preload

SETTING

WHEEL

adjustment wheel.

2. Rotate the setting wheel counter-clockwise (CCW) to increase handle force. The numbers will display higher.

To decrease handle force rotate the setting wheel clockwise (CW).

3. Release the link to lock the setting wheel in place.

4. Check the crimp specifications or conduct a pull test after tool handle preload force is adjusted.

Warranty

This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital

components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30

days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will

not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,

fixturing, or use of handle extensions voids this warranty.

CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.

CAUTIONS:

1. Manually powered hand tools are intended for low volume or field repair. This tool is NOT intended for

production use. Repetitive use of this tool should be avoided.

2. Insulated rubber handles are not protection against electrical shock.

3. Wear eye protection at all times.

4. Use only the Molex terminals specified for crimping with this tool.

Certification

Molex does not certify or re-certify hand tools but rather supplies the following guidelines for customers to re-certify

hand tools.

% This tool is qualified to pull force only. See the Molex web site for the Quality Crimp Handbook for more

information on pull testing.

% If the tool does not meet minimum pull force values, handle preload should be increased and the pull test

rerun, (See How to Adjust Preload).

% When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service and

replaced.

Doc No: ATS-638194400 Release Date: 10-31-08

Revision: A

Revision Date: 10-31-08

UNCONTROLLED COPY

Page 6 of 7

Share Link: