501930-1200 Ver la hoja de datos (PDF) - Molex Connectors
Número de pieza
componentes Descripción
Fabricante
501930-1200 Datasheet PDF : 7 Pages
| |||
Hand Crimp Tool For 1.25mm (.049") Pitch Crimp Terminals
CONDITIONS:
After crimping, the conductor profile should measure the following.
Terminal Series No.
501930
502381
Wire Size
AWG mm2
26 0.13
28 0.08
26 0.13
28 0.08
Conductor
Crimp Height Crimp Width (Ref)
mm
In.
mm
In.
0.56-0.61 .022-.024 0.80 .031
0.53-0.58 .021-.023 0.80 .031
0.56-0.61 .022-.024 0.80 .031
0.53-0.58 .021-.023 0.80 .031
Profile
501930 502381
26 28 26 28
X
X
X
X
Terminal Series No.
501930
502381
Wire Size
AWG mm2
26 0.13
28 0.08
26 0.13
28 0.08
Insulation (Ref)
Crimp Height Crimp Width
mm
In. mm In.
1.19-1.25 .047-.049 0.80 .031
1.15-1.21 .045-.048 0.80 .031
1.18-1.28 .046-.050 0.80 .031
1.15-1.25 .045-.049 0.80 .031
Pull Force Minimum
N
Lb.
9.8
2.20
9.8
2.20
9.8
2.20
9.8
2.20
OPERATION
CAUTION: Install only Molex terminals listed above with this tool. Do not crimp hardened objects as damage can
occur to the tool or die.
Open the tool by squeezing the handles together. At the end of the closing
stroke, the ratchet mechanism will release the handles and the hand tool will
spring open. See Figure 1.
Crimping Terminals
HANDLE WILL
SPRING OPEN
1. Select the desired terminal listed in the preceding
charts.
2. Make sure the center of the locator is in the down
position. With the locator attached, push the
locator button on the back of the hand tool to
bring the locator forward through the tooling. See
Figure 2.
3. While holding the locator button in, load the
terminal into the proper nest opening in the
locator based on the wire gauge or terminal type
markings on the hand tooling. See Figure 3.
Figure 2
LOCATOR
IN DOWN
POSTION
SQUEEZE
HANDLES
TOGETHER
Figure 1
PUSH ON THE
LOCATOR BUTTON
Doc No: ATS-638194400 Release Date: 10-31-08
Revision: A
Revision Date: 10-31-08
UNCONTROLLED COPY
Page 2 of 7
Share Link: 