C0603H101J5GACTU Ver la hoja de datos (PDF) - Unspecified
Número de pieza
componentes Descripción
Fabricante
C0603H101J5GACTU Datasheet PDF : 24 Pages
| |||
Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
High Temperature (200°C), C0G Dielectric, 10 – 200 VDC (Industrial Grade)
Electrical Parameters/Characteristics
Item
Parameters/Characteristics
Operating Temperature Range −55°C to +200°C
Capacitance Change with Reference to
+25°C and 0 VDC Applied (TCC)
±30 ppm/ºC (up to 200ºC)
Aging Rate (Maximum % Capacitance Loss/Decade Hour)
1Dielectric Withstanding Voltage (DWV)
2Dissipation Factor (DF) Maximum Limit at 25ºC
0%
250% of rated voltage
(5±1 seconds and charge/discharge not exceeding 50 mA)
0.1%
3Insulation Resistance (IR) Minimum Limit at 25°C
1,000 megohm microfarads or 100 GΩ
(Rated voltage applied for 120±5 seconds at 25°C)
1 DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the
capacitor.
2 Capacitance and dissipation factor (DF) measured under the following conditions:
1 MHz ±100 kHz and 1.0 ±0.2 Vrms if capacitance ≤ 1,000 pF
1 kHz ±50 Hz and 1.0 ±0.2 Vrms if capacitance > 1,000 pF
3 To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 & Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to “ON.”
Post Environmental Limits
Dielectric
C0G
High Temperature Life, Biased Humidity, Moisture Resistance
Rated DC
Voltage
All
Capacitance
Value
All
Dissipation Factor Capacitance
(Maximum %)
Shift
0.5
0.3% or ±0.25 pF
Insulation
Resistance
10% of Initial
Limit
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com
C1001_C0G_200C_SMD • 7/29/2016 5
Share Link: 