SBP200375WE2.5 Ver la hoja de datos (PDF) - TE Connectivity
Número de pieza
componentes Descripción
Fabricante
SBP200375WE2.5 Datasheet PDF : 8 Pages
| |||
SBP
Self Laminating Wire and Cable Markers
Typical Label Thickness
• Label (including adhesive): 0.085 mm / 0.0033 inch
• Liner: 0.060 mm / 0.0024 inch
Technical Performance
Print Permanence
Marking of Electrical Insulating Materi-
als, SAE AS 4952
Resistance to Solvents, MIL STD 202
Method 215
Fluid Exposure
•
Isopropyl alcohol
•
IRM 902
•
MIL PRF 23699
•
MIL-H-83282
•
Diesel Fuel
•
Kilfrost DF plus
•
Tap water
•
5% Salt solution
•
Detergent (1% solution)
•
Brake fluid
•
Jet A fuel
Adhesion to FTM1 (180°)
Test surface:
•
Stainless steel
•
Glass
•
Aluminium
•
Polypropylene
•
Tufnol
•
To SBP Label Surface (wrap)
•
Adhesive to Adhesive (flag)
Flammability
Average burn time, ASTM D1000
Requirement
Results
Legible after 50 rubs 1kg weight
with an eraser
Pass
Legible after 30 wipes
Pass
Adhesive Printed legend
Labels to remain on wire and legi-
ble / SAE AS 5942 (TE doc 109-
121012)
Wrap and flagged installed sam-
ples, 24 hours immersion 23°C
followed by 20 rubs
Pass*
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
*Some loosening of flag possible
Typical Peel force (N/25mm (oz/in.))
FTM1 (180°)
20min Dwell
72hr Dwell
20 (73)
17 (62)
9 (32)
10 (35)
15 (53)
17 (64)
20 (73)
22 (82)
21 (75)
18 (64)
9 (32)
20 (73)
23 (83)
20 (73)
Burn time less than 10 seconds.
Pass, typical burn time 7second
Burn rate FMVSS 302
Maximum burn rate 120mm/min.
Pass, typical burn rate 35mm/min
Weatherability
Artificial weathering to ASTM G154
Labels to remain on wire and legi-
ble after 3000hr, UV-A and UV-B
Pass, samples remain legible and do not
unwrap or unravel*
* Note orange and red may fade under
UV, print remains legible.
Thermal performance
Heat Aging
Labels to remain on wire and legi- Pass, samples remain legible and do not
ble after 168hr at 90±2°C
unwrap or unravel
Thermal Cycling
Labels to remain in on wire and
legible after 10 cycles of 1hr @
-50°C then 1hr @ 90°C
Pass, samples remain legible and do not
unwrap or unravel
Where possible, TE have tested product as a finished item, including the print. Operational tests are followed by an
assessment of mark adherence to validate fit form and function.
PAGE 3
INDUSTRIAL /// TTDS-211 – SBP TECHNICAL DATA SHEET
Share Link: 