TC7660SCPA723 Ver la hoja de datos (PDF) - Microchip Technology

Número de pieza

componentes Descripción

Fabricante

TC7660SCPA723

Super Charge Pump DC-to-DC Voltage Converter

Microchip Technology 

TC7660S

3.0 PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 3-1.

TABLE 3-1:

Pin No.

1

2

3

4

5

6

7

8

PIN FUNCTION TABLE

Symbol

BOOST

CAP+

GND

CAP-

VOUT

LV

OSC

V+

Description

Switching Frequency boost pin

Charge pump capacitor positive terminal

Ground terminal

Charge pump capacitor negative terminal

Output voltage

Low voltage pin. Connect to GND for V+ < 3.5V

Oscillator control input. Bypass with an external capacitor to slow the oscillator.

Power supply positive voltage input

3.1 Switching Frequency Boost Pin

(Boost)

By connecting the boost pin (pin 1), the switching

frequency of the charge pump is increased from 10 kHz

typical to 45 kHz typical. By connecting the boost pin

(pin1), to the V+ pin (pin 8), the switching frequency of

the charge pump is increased from 10 kHz typical to

45 kHz typical.

3.2 Charge Pump Capacitor (CAP+)

Positive connection for the charge pump capacitor, or

flying capacitor, used to transfer charge from the input

source to the output. In the voltage-inverting

configuration, the charge pump capacitor is charged to

the input voltage during the first half of the switching

cycle. During the second half of the switching cycle, the

charge pump capacitor is inverted and charge is

transferred to the output capacitor and load.

It is recommended that a low ESR (equivalent series

resistance) capacitor be used. Additionally, larger

values will lower the output resistance.

It is recommended that a low ESR capacitor be used.

Additionally, larger values will lower the output ripple.

3.6 Low Voltage Pin (LV)

The low voltage pin ensures proper operation of the

internal oscillator for input voltages below 3.5V. The low

voltage pin should be connected to ground (GND) for

input voltages below 3.5V. Otherwise, the low voltage

pin should be allowed to float.

3.7 Oscillator Control Input (OSC)

The oscillator control input can be utilized to slow down

or speed up the operation of the TC7660S. Refer to

Section 5.4 “Changing the TC7660S Oscillator

Frequency”, for details on altering the oscillator

frequency.

3.8 Power Supply (V+)

Positive power supply input voltage connection. It is

recommended that a low ESR capacitor be used to

bypass the power supply input to ground (GND).

3.3 Ground (GND)

Input and output zero volt reference.

3.4 Charge Pump Capacitor (CAP-)

Negative connection for the charge pump capacitor, or

flying capacitor, used to transfer charge from the input

to the output. Proper orientation is imperative when

using a polarized capacitor.

3.5 Output Voltage (VOUT)

Negative connection for the charge pump output

capacitor. In the voltage-inverting configuration, the

charge pump output capacitor supplies the output load

during the first half of the switching cycle. During the

second half of the switching cycle, charge is restored to

the charge pump output capacitor.

 2001-2015 Microchip Technology Inc.

DS20001467C-page 7

Share Link: