D4BS Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

D4BS

Safety-door Switch

Unspecified 

Wiring

Do not connect the lead wires directly to the terminals. Connect the

lead wires through insulation tubes and M3.5 crimp terminals.

Tighten each terminal screw within the proper torque range.

The proper lead wire is AWG20 to AWG14 (0.5 to 2.5 mm2) in size.

dz dia.: 3.7

D dia.: 4.5

B:

7.0

L:

20.2

F:

7.7

I:

9.0 (mm)

D dia.

dz dia.

Make sure that all crimp terminals are correctly connected and

located within the casing or cover as shown below.

Correct

Incorrect

Terminal screw

Connector

Tighten the connector to a suitable torque. Excessive tightening

torque may damage the casing.

When using a 1/2-14NPT conduit, apply sealing tape between con-

nector and conduit opening so that the enclosure will confirm to IP67.

If using a Pg13.5 conduit, use an ABS-08 Pg13.5 connector or an

ABS-12 Pg13.5 connector (manufactured by Nippon Flex).

Use a connector (SC Series, sold separately) suitable for the outer

diameter of the cable.

When wiring a 3-conduit model, securely tighten the cap screw pro-

vided for unused conduit openings.

Maintenance and Repairs

The user must not maintain or repair equipment incorporating any

D4BS model. Contact the manufacturer of the equipment for any

maintenance or repairs required.

Crimp terminal

Correct

Crimp

terminal

Terminal screw

Cover

Incorrect

Terminal screw

Cover

Casing

Casing

Crimp terminal

Crimp terminal

Crimp terminal

D-112

Safety Sensors / Components

Share Link: