ML65245CK Ver la hoja de datos (PDF) - Micro Linear Corporation

Número de pieza

componentes Descripción

Fabricante

ML65245CK

High Speed Octal Buffer Transceivers

Micro Linear Corporation 

FUNCTIONAL DESCRIPTION

The ML65245 and ML65L245 are very high speed non-

inverting transceivers with three-state outputs which are

ideally suited for bus-oriented applications. They provide

a low propagation delay by using an analog design

approach (a high speed unity gain buffer), as compared to

conventional digital approaches. The ML65245 and

ML65L245 follow the pinout and functionality of the

industry standard FCT245 series of transceivers and are

intended to replace them in designs where the

propagation delay is a critical part of the system design

considerations. The ML65245 and ML65L245 are capable

of driving load capacitances several times larger than their

input capacitance. They are configured so that signals

pass from Ai to Bi, or from Bi to Ai, depending on the state

of the T/R pin. All of the signal lines can be made high

impedance via the OE pin.

These unity gain analog buffers achieve low propagation

delays by having the output follow the input with a small

offset. The output rise and fall times will closely match

those of the input waveform. All inputs and outputs have

Schottky clamp diodes to handle undershoot or overshoot

noise suppression in unterminated applications. All

outputs have ground bounce suppression (typically

< 400mV), high drive output capability with almost

immediate response to the input signal, and low output

skew.

The IOL current drive capability of a buffer/line driver is

often interpreted as a measure of its ability to sink current

ML65245**/ML65L245*

in a dynamic sense. This may be true for CMOS buffer/

line drivers, but it is not true for the ML65245 and

ML65L245. This is because the their sink and source

current capability depends on the voltage difference

between the output and the input. The ML65245 can sink

or source more than 100mA to a load when the load is

switching due to the fact that during the transition, the

difference between the input and output is large. IOL is

only significant as a DC specification, and is 25mA.

ARCHITECTURAL DESCRIPTION

Until now, buffer/line drivers have been implemented in

CMOS logic and made to be TTL compatible by sizing the

input devices appropriately. In order to buffer large

capacitances with CMOS logic, it is necessary to cascade

an even number of inverters, each successive inverter

larger than the preceding, eventually leading to an inverter

that will drive the required load capacitance at the

required frequency. Each inverter stage represents an

additional delay in the gating process because in order for

a single gate to switch, the input must slew more than half

of the supply voltage. The best of these CMOS buffers has

managed to drive a 50pF load capacitance with a delay of

3.2ns. Micro Linear has produced an octal transceiver

with a delay less than 1.7ns by using a unique circuit

architecture that does not require cascaded logic gates.

The ML65245 uses a feedback technique to produce an

output that follows the input. If the output voltage is not

close to the input, then the feedback circuitry will source

or sink enough current to the load capacitance to correct

the discrepancy.

VCC

R8

Q1

R3

R4

R1

IN

Q4

Q3

Q5

R5

R2

Q6

R6

Q2

R7

OUT

Q7

GND

Figure 5. One buffer cell of the ML65245

5

Share Link: