SG3527 Ver la hoja de datos (PDF) - Motorola => Freescale
Número de pieza
componentes Descripción
Fabricante
SG3527 Datasheet PDF : 8 Pages
| |||
SG3525A SG3527A
MAXIMUM RATINGS (Note 1)
Rating
Symbol
Value
Unit
Supply Voltage
Collector Supply Voltage
Logic Inputs
VCC
VC
+40
Vdc
+40
Vdc
–0.3 to +5.5
V
Analog Inputs
Output Current, Source or Sink
Reference Output Current
Oscillator Charging Current
–0.3 to VCC
V
IO
±500
mA
Iref
50
mA
5.0
mA
Power Dissipation (Plastic & Ceramic Package)
PD
TA = +25°C (Note 2)
TC = +25°C (Note 3)
Thermal Resistance Junction–to–Air
RθJA
Thermal Resistance Junction–to–Case
RθJC
Operating Junction Temperature
TJ
Storage Temperature Range
Tstg
Lead Temperature (Soldering, 10 seconds)
TSolder
NOTES: 1. Values beyond which damage may occur.
2. Derate at 10 mW/°C for ambient temperatures above +50°C.
3. Derate at 16 mW/°C for case temperatures above +25°C.
1000
2000
100
60
+150
–55 to +125
+300
mW
°C/W
°C/W
°C
°C
°C
RECOMMENDED OPERATING CONDITIONS
Characteristics
Supply Voltage
Collector Supply Voltage
Output Sink/Source Current
(Steady State)
(Peak)
Reference Load Current
Oscillator Frequency Range
Oscillator Timing Resistor
Oscillator Timing Capacitor
Deadtime Resistor Range
Operating Ambient Temperature Range
Symbol
Min
Max
Unit
VCC
VC
IO
8.0
35
Vdc
4.5
35
Vdc
mA
0
±100
0
±400
Iref
0
20
mA
fosc
0.1
400
kHz
RT
2.0
150
kΩ
CT
0.001
0.2
µF
RD
0
500
Ω
TA
0
+70
°C
APPLICATION INFORMATION
Shutdown Options (See Block diagram, front page)
Since both the compensation and soft–start terminals
(Pins 9 and 8) have current source pull–ups, either can
readily accept a pull–down signal which only has to sink a
maximum of 100 µA to turn off the outputs. This is subject to
the added requirement of discharging whatever external
capacitance may be attached to these pins.
An alternate approach is the use of the shutdown circuitry
of Pin 10 which has been improved to enhance the available
shutdown options. Activating this circuit by applying a
positive signal on Pin 10 performs two functions: the PWM
latch is immediately set providing the fastest turn–off signal to
the outputs; and a 150 µA current sink begins to discharge
the external soft–start capacitor. If the shutdown command is
short, the PWM signal is terminated without significant
discharge of the soft–start capacitor, thus, allowing, for
example, a convenient implementation of pulse–by–pulse
current limiting. Holding Pin 10 high for a longer duration,
however, will ultimately discharge this external capacitor,
recycling slow turn–on upon release.
Pin 10 should not be left floating as noise pickup could
conceivably interrupt normal operation.
2
MOTOROLA ANALOG IC DEVICE DATA
Share Link: 