MX29LV800BB Ver la hoja de datos (PDF) - Macronix International

Número de pieza

componentes Descripción

Fabricante

MX29LV800BB

8M-BIT [1Mx8/512K x16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY

Macronix International 

MX29LV800BT/BB

TABLE 5. MX29LV800BT/BB COMMAND DEFINITIONS

Command

First Bus

Bus Cycle

Second Bus Third Bus

Cycle

Cycle

Fourth Bus

Cycle

Cycle Addr Data Addr Data Addr Data Addr Data

Fifth Bus

Cycle

Sixth Bus

Cycle

Addr Data Addr Data

Reset

1 XXXH F0H

Read

1 RA RD

Read Silicon ID Word 4 555H AAH 2AAH 55H 555H 90H ADI DDI

Byte 4 AAAH AAH 555H 55H AAAH 90H ADI DDI

Sector Protect Word 4 555H AAH 2AAH 55H 555H 90H (SA) XX00H

Verify

x02H XX01H

Byte 4 AAAH AAH 555H 55H AAAH 90H (SA) 00H

x04H 01H

Program

Word 4 555H AAH 2AAH 55H 555H A0H PA PD

Byte 4 AAAH AAH 555H 55H AAAH A0H PA PD

Chip Erase

Word 6 555H AAH 2AAH 55H 555H 80H 555H AAH 2AAH 55H 555H 10H

Byte 6 AAAH AAH 555H 55H AAAH 80H AAAH AAH 555H 55H AAAH 10H

Sector Erase Word 6 555H AAH 2AAH 55H 555H 80H 555H AAH 2AAH 55H SA 30H

Byte 6 AAAH AAH 555H 55H AAAH 80H AAAH AAH 555H 55H SA 30H

Sector Erase Suspend 1 XXXH B0H

Sector Erase Resume 1 XXXH 30H

CFI Query

Word 1 55H 98

Byte 1 AAH 98

Note:

1. ADI = Address of Device identifier; A1=0, A0 = 0 for manufacturer code,A1=0, A0 = 1 for device code. A2-A18=do not care.

(Refer to table 3)

DDI = Data of Device identifier : C2H for manufacture code, 22DA/DA(Top), and 225B/5B(Bottom) for device code.

X = X can be VIL or VIH

RA=Address of memory location to be read.

RD=Data to be read at location RA.

2. PA = Address of memory location to be programmed.

PD = Data to be programmed at location PA.

SA = Address of the sector.

3. The system should generate the following address patterns: 555H or 2AAH to Address A10~A0 in word mode/AAAH or

555H to Address A10~A-1 in byte mode.

Address bit A11~A18=X=Don't care for all address commands except for Program Address (PA) and Sector Address (SA).

Write Sequence may be initiated with A11~A18 in either state.

4. For Sector Protect Verify operation: If read out data is 01H, it means the sector has been protected. If read out data is 00H,

it means the sector is still not being protected.

5. Any number of CFI data read cycle are permitted.

P/N:PM1062

REV. 1.3, DEC. 20, 2004

10

Share Link: