M62436FP
Switch Settings
Pin 21 SRS Surround
SRS ON
SRS OFF
SRS On/Off Switch
H
L
Pin 20 Focus
FOCUS ON
FOCUS OFF
Focus On/Off Switch
H
L
Pin 19 Focus Position
Focus Position "H"
Focus Position "L"
Focus H/L Switch
H
L
Note: The bypass mode can be selected by setting the
SRS on/off switch and Focus on/off switch to "L".
External Resistors
The midrange through high-range gain of the Focus circuit of the M62436FP can be specified using an externally
connected resistor.
The midrange through high-range gain is set by the resistance division value between the 0.22 µ[?] connected to pin 7
and REF. The M62436FP allows the user-specified gain to be set to high or low by switching the Focus position H/L
setting of pin 18. The recommended resistance value settings are listed below.
1. Focus Position “H” Setting
R17+R18
R16+R17+R18
setting possible
2. Focus Position “L” Setting
R18
R16+R17+R18
setting possible
Recommended Setting Values
R16 = 390 , R17 = 200 , R18 = 390
Focus Position "H" = 60%
Focus Position "L" = 40%
External
C10
7
0.22µ R16
8
R17
∗ R16+R17+R18
9
=1kΩ
R18
29
REF
Right channel external resistor
FOCUS
position "H"
FOCUS
position "L"
Notes 1. The left channel setting pins 7, 8, and 9 correspond to pins 32, 31, and 30.
2. Settings should be made so that R16 + R17 + R18 = 1 kΩ.
The effect (full-range gain) of the Focus circuit of the M62436FP can be reduced using an externally connected resistor.
Rev.1.0, Sep.19.2003, page 5 of 11