0603YC104KAT2A Ver la hoja de datos (PDF) - Microchip Technology
Número de pieza
componentes Descripción
Fabricante
0603YC104KAT2A Datasheet PDF : 26 Pages
| |||
MCP2210 BREAKOUT MODULE
USER’S GUIDE
Chapter 2. Installation and Operation
2.1 INTRODUCTION
The MCP2210 Breakout Module is designed to demonstrate the device as a
USB-to-SPI (Master) bridge solution.
The package is comprised of a single board and has the following features:
• Small plug-in board with DIP form factor (600 millimeters overall row spacing
between pins)
• Mini-USB connector
• Access to SPI bus and all GP signals through USB port
• PICkit™ Serial Analyzer compatible header
• 3.3 or 5V jumper selectable VDD; the breakout board can be used to supply up to
500 mA to the rest of the system. The board already provides a signal trace
between the VDD and the 3.3V rail. For systems requiring 5V VDD power supply,
VDD header must be mounted on the board. A jumper will close the middle pin and
the 5V pin.
2.2 BOARD SETUP
Follow these steps to set up the MCP2210 Breakout Module:
1. Download the support material (PC applications and DLL libraries) that can be
found on the board’s page, on the Microchip web site.
2. Attach the MCP2210 Breakout Module to a board that has one or more SPI slave
devices attached to a bus (SPI).
3. Plug the MCP2210 Breakout Module in to a PC.
4. The computer operating system will automatically install the driver for this board.
When the installation is complete, the board is ready for operation.
5. Install the downloaded PC software.
6. Start the SPI Terminal utility.
© 2012 Microchip Technology Inc.
DS52056A-page 11
Share Link: 