ADG758BCP Ver la hoja de datos (PDF) - Analog Devices
Número de pieza
componentes Descripción
Fabricante
ADG758BCP Datasheet PDF : 12 Pages
| |||
ADG758/ADG759
TERMINOLOGY
VDD
VSS
GND
S
D
IN
RON
RFLAT(ON)
IS (OFF)
ID (OFF)
ID, IS (ON)
VD (VS)
CS (OFF)
CD (OFF)
CD, CS (ON)
CIN
tTRANSITION
tON (EN)
tOFF (EN)
tOPEN
Off Isolation
Crosstalk
Charge
Injection
On Response
On Loss
VINL
VINH
IINL (IINH)
IDD
ISS
Most Positive Power Supply Potential
Most Negative Power Supply in a dual-supply application. In single-supply applications, this should be tied to
ground at the device.
Ground (0 V) Reference
Source Terminal. May be an input or output.
Drain Terminal. May be an input or output.
Logic Control Input
Ohmic Resistance between D and S
Flatness is defined as the difference between the maximum and minimum value of ON resistance as measured over
the specified analog signal range.
Source Leakage Current with the Switch OFF
Drain leakage Current with the Switch OFF
Channel Leakage current with the Switch ON
Analog Voltage on Terminals D, S
OFF Switch Source Capacitance. Measured with reference to ground.
OFF Switch Drain Capacitance. Measured with reference to ground.
ON Switch Capacitance. Measured with reference to ground.
Digital Input Capacitance
Delay Time measured between the 50% and 90% points of the digital inputs and the switch ON condition when
switching from one address state to another.
Delay Time between the 50% and 90% points of the EN digital input and the switch ON condition.
Delay Time between the 50% and 90% points of the EN digital input and the switch OFF condition.
OFF Time measured between the 80% points of both switches when switching from one address state to another.
A measure of unwanted signal coupling through an OFF switch.
A measure of unwanted signal which is coupled through from one channel to another as a result of parasitic capacitance.
A measure of the glitch impulse transferred from the digital input to the analog output during switching.
The Frequency Response of the ON Switch.
The Loss Due to the ON Resistance of the Switch
Maximum Input Voltage for Logic “0”
Minimum Input Voltage for Logic “1”
Input Current of the Digital Input
Positive Supply Current
Negative Supply Current
–6–
REV. A
Share Link: 